Loading ...
Loading ...
Loading ...
Manage Device Security
300
ProSAFE 10-Gigabit Smart Managed Switch XS728T and XS748T User Manual
• Match Every. Select whether all packet must match the selected IPv6 ACL rule:
- Disable. Not all packets need to match the selected IPv6 ACL rule. You can
configure other match criteria on the page.
- Enable. All packets must match the selected IPv6 ACL rule and are either
permitted or denied. In this case, you cannot configure other match criteria on the
page.
• Protocol Type. Specify the IPv6 protocol type in one of the following ways:
- From the Protocol Type menu, select IPv6, ICMPv6, TCP, or UDP.
- From the Protocol Type menu, select Other, and in the associated field, specify
an integer ranging from 0 to 255. This number represents the IPv6 protocol.
• Source Prefix and Prefix Length. In the Source Prefix field and Prefix Length field,
enter the IPv6 prefix combined with the IPv6 prefix length of the network or host from
which the packet is being sent. The valid range for the prefix length is 0–128.
• Source L4 port. The options are available only when the protocol is set to TCP or UDP.
Use the source L4 port option to specify relevant matching conditions for L4 port
numbers in the IPv6 ACL rule.
The source port protocols are domain, echo, ftp, ftpdata, http, smtp, snmp, telnet,
tftp, and www. Each of these values translates into its equivalent port number.
Select Other from the menu to enter a port number from 0 to 65535.
• Destination Prefix and Prefix Length. In the Destination Prefix field and Prefix
Length field, enter the IPv6 prefix combined with the IPv6 prefix length of the network
or host to which the packet is being sent. The valid range for the prefix length is
0–128.
• Destination L4 port. The options are available only when the protocol is set to TCP or
UDP. Use the source L4 port option to specify relevant matching conditions for L4 port
numbers in the IPv6 ACL rule.
The source port protocols are domain, echo, ftp, ftpdata, http, smtp, snmp, telnet,
tftp, and www. Each of these values translates into its equivalent port number
.
Select
Other from the menu to enter a port number from 0 to 65535.
• IPv6 DSCP Service. Specify the IP DiffServ Code Point (DSCP) field. This is an
optional configuration.
Select one of the IP DiffServ Code Point (DSCP) keywords from the menu. The DSCP
is defined as the high-order 6 bits of the service type octet in the IP header. To specify
a numeric value, select Other from the menu and enter a numeric value from 0 to 63.
9. Click the Apply button.
The updated configuration is sent to the switch. Configuration changes take effect
immediately.
Loading ...
Loading ...
Loading ...