Loading ...
Loading ...
Loading ...
315
5-4. Using the driving support systems
Owners Manual_USA_A6717BE-A_en
5
Driving
■ The system can be operated
when
● The power switch is in ON.
● SUBARU Parking Assist function
is on.
● The vehicle speed is less than
about 6 mph (10 km/h).
● A shift position other than P is
selected.
■ Sensor detection information
● The sensor’s detection areas are
limited to the areas around the
vehicle’s front and rear bumpers.
● The following situations may occur
during use.
• Depending on the shape of the
object and other factors, the
detection distance may shorten, or
detection may be impossible.
• Detection may be impossible if
static objects draw too close to the
sensor.
• There will be a short delay
between static object detection
and display (warning buzzer
sounds). Even at low speeds,
there is a possibility that the object
will come within 11.9 in. (30 cm)
before the display is shown and
the warning buzzer sounds.
• It might be difficult to hear the
buzzer due to the volume of the
audio system or air flow noise of
the air conditioning system.
• It may be difficult to hear the
sound of this system due to the
buzzers of other systems.
WARNING
● Do not damage the sensors,
and always keep them clean.
● Do not attach a sticker or install
an electronic component, such
as a backlit license plate (espe-
cially fluorescent type), fog
lights, fender pole or wireless
antenna near a radar sensor.
● Do not subject the surrounding
area of the sensor to a strong
impact. If subjected to an
impact, have the vehicle
inspected by your SUBARU
dealer. If the front or rear
bumper needs to be
removed/installed or replaced,
contact your SUBARU dealer.
● Do not modify, disassemble or
paint the sensors.
● Do not attach a license plate
cover.
● Keep your tires properly
inflated.
■ When to disable the function
In the following situations, disable
the function as it may operate
even though there is no possibility
of a collision.
● Failing to observe the warnings
above.
● A non-genuine SUBARU sus-
pension (lowered suspension,
etc.) is installed.
■ Notes when washing the vehi-
cle
Do not apply intensive bursts of
water or steam to the sensor
area.
Doing so may result in the sensor
malfunctioning.
● When using a high pressure
washer to wash the vehicle, do
not spray the sensors directly,
as doing so may cause a sensor
to malfunction.
● When using steam to clean the
vehicle, do not direct steam too
close to the sensors as doing so
may cause a sensor to malfunc-
tion.
Loading ...
Loading ...
Loading ...