Loading ...
Loading ...
Loading ...
DTC P0340 CMP SENSOR (PHASE)
EC-649
[QR (WITHOUT EURO-OBD)]
C
D
E
F
G
H
I
J
K
L
M
A
EC
Specification data are reference values and are measured between each terminal and ground.
Pulse signal is measured by CONSULT-II.
CAUTION:
Do not use ECM ground terminals when measuring input/output voltage. Doing so may result in dam-
age to the ECM's transistor. Use a ground other than ECM terminals, such as the ground.
: Average voltage for pulse signal (Actual pulse signal can be confirmed by oscilloscope.)
Diagnostic Procedure EBS010ZT
1. CHECK STARTING SYSTEM
Turn ignition switch to START position.
Yes or No
Yes >> GO TO 2.
No >> Check starting system. (Refer to SC-21, "
STARTING SYSTEM" .)
TERMI-
NAL
NO.
WIRE
COLOR
ITEM CONDITION DATA (DC Voltage)
13 L/W
Camshaft position
sensor (PHASE)
[Engine is running]
● Warm-up condition
● Idle speed
NOTE:
The pulse cycle changes depending on rpm at idle
1.0 - 4.0V
[Engine is running]
● Engine speed is 2,000 rpm
1.0 - 4.0V
29 B
Sensor ground
(Camshaft position
sensor)
[Engine is running]
● Warm-up condition
● Idle speed
Approximately 0V
PBIB0525E
PBIB0526E
Does the engine turn over?
Does the starter motor operate?
Loading ...
Loading ...
Loading ...