Loading ...
Loading ...
Loading ...
EC-110
[QR (WITH EURO-OBD)]
TROUBLE DIAGNOSIS
ACTIVE TEST MODE
Test Item
*1:Leaving cooling fan OFF with CONSULT-II while engine is running may cause the engine to overheat.
DTC & SRT CONFIRMATION MODE
SRT STATUS Mode
For details, refer to EC-55, "SYSTEM READINESS TEST (SRT) CODE" .
SRT WORK SUPPORT Mode
This mode enables a technician to drive a vehicle to set the SRT while monitoring the SRT status.
TEST ITEM CONDITION JUDGEMENT CHECK ITEM (REMEDY)
FUEL INJEC-
TION
● Engine: Return to the original
trouble condition
● Change the amount of fuel injec-
tion using CONSULT-II.
If trouble symptom disappears, see
CHECK ITEM.
● Harness and connectors
● Fuel injector
● Heated oxygen sensor 1
IGNITION TIM-
ING
● Engine: Return to the original
trouble condition
● Timing light: Set
● Retard the ignition timing using
CONSULT-II.
If trouble symptom disappears, see
CHECK ITEM.
● Perform Idle Air Volume Learning.
POWER BAL-
ANCE
● Engine: After warming up, idle
the engine.
● Air conditioner switch: OFF
● Shift lever: N (A/T), Neutral (M/T)
● Cut off each injector signal one at
a time using CONSULT-II.
Engine runs rough or dies.
● Harness and connectors
● Compression
● Fuel injector
● Power transistor
● Spark plug
● Ignition coil
COOLING FAN*
1
● Ignition switch: ON
● Turn the cooling fan LOW, HI,
OFF with CONSULT-II.
Cooling fan moves and stops.
● Harness and connectors
● Cooling fan relay
● Cooling fan motor
ENG COOLANT
TEMP
● Engine: Return to the original
trouble condition
● Change the engine coolant tem-
perature using CONSULT-II.
If trouble symptom disappears, see
CHECK ITEM.
● Harness and connectors
● Engine coolant temperature sen-
sor
● Fuel injector
FUEL PUMP
RELAY
● Ignition switch: ON (Engine
stopped)
● Turn the fuel pump relay ON and
OFF using CONSULT-II and lis-
ten to operating sound.
Fuel pump relay makes the operat-
ing sound.
● Harness and connectors
● Fuel pump relay
VIAS SOL VALVE
● Ignition switch: ON
● Turn solenoid valve ON and OFF
with CONSULT-II and listen for
operating sound.
Solenoid valve makes an operating
sound.
● Harness and connectors
● Solenoid valve
PURG VOL
CONT/V
● Engine: After warming up, run
engine at 1,500 rpm.
● Change the EVAP canister purge
volume control solenoid valve
opening percent using CON-
SULT-II.
Engine speed changes according to
the opening percent.
● Harness and connectors
● Solenoid valve
V/T ASSIGN
ANGLE
● Engine: Return to the original
trouble condition
● Change intake valve timing using
CONSULT-II.
If trouble symptom disappears, see
CHECK ITEM.
● Harness and connectors
● Intake valve timing control sole-
noid valve
Loading ...
Loading ...
Loading ...