Loading ...
Loading ...
Loading ...
EC-1464
[YD (WITHOUT EURO-OBD)]
GLOW CONTROL SYSTEM
Component Inspection EBS0125K
GLOW RELAY
Check continuity between glow relay terminals 3 and 5 under the fol-
lowing conditions.
Operation takes less than 1 second.
GLOW PLUG
1. Remove glow plug connecting plate.
2. Check glow plug resistance.
NOTE:
● Do not bump glow plug heating element. If it is bumped,
replace glow plug with a new one.
● If glow plug is dropped from a height of 10 cm (3.94 in) or
higher, replace with a new one.
● If glow plug installation hole is contaminated with car-
bon, remove it with a reamer or suitable tool.
● Hand-tighten glow plug by turning it two or three times,
then tighten using a tool to specified torque.
Removal and Installation EBS0125L
GLOW PLUG
Refer to EM-152, "GLOW PLUG" .
Conditions Continuity
12V direct current supply between ter-
minals 1 and 2
Yes
No current supply No
PBIB0428E
Resistance: Approximately 0.8 Ω [at 25°C (77°F)]
: 20.1 N-m (2.1 kg-m, 15 ft-lb)
PBIB0429E
Loading ...
Loading ...
Loading ...