Loading ...
Loading ...
Loading ...
DTC P0016 CKP - CMP CORRELATION
EC-1271
[YD (WITHOUT EURO-OBD)]
C
D
E
F
G
H
I
J
K
L
M
A
EC
DTC P0016 CKP - CMP CORRELATION PFP:10328
On Board Diagnosis Logic EBS011Y1
The MI will not light up for this self-diagnosis.
DTC Confirmation Procedure EBS011Y2
NOTE:
If DTC Confirmation Procedure has been previously conducted, always turn ignition switch OFF and wait at
least 10 seconds before conducting the next test.
WITH CONSULT-II
1. Turn ignition switch ON.
2. Select “DATA MONITOR” mode with CONSULT-II.
3. Start engine and let it idle for at least 5 seconds.
4. If 1st trip DTC is detected, go to EC-1271, "
Diagnostic Proce-
dure" .
Diagnostic Procedure EBS011Y3
1. CHECK CAMSHAFT POSITION SENSOR
Refer to EC-1356, "
Component Inspection" .
OK or NG
OK >> GO TO 2.
NG >> Replace camshaft position sensor.
2. CHECK SPROCKET
Visually check for chipping signal plate gear tooth.
OK or NG
OK >> GO TO 3.
NG >> Remove debris and clean the signal plate or replace sprocket.
3. CHECK CRANKSHAFT POSITION SENSOR
Refer to EC-1368, "
Component Inspection" .
OK or NG
OK >> GO TO 4.
NG >> Replace crankshaft position sensor.
DTC No.
Trouble diagnosis
name
DTC detecting condition Possible cause
P0016
Crankshaft position -
camshaft position cor-
relation
The correlation between crankshaft position sen-
sor signal and camshaft position sensor signal is
out of the normal range.
● Camshaft position sensor
● Crankshaft position sensor
● Timing chain
● Signal plate
SEF817Y
Loading ...
Loading ...
Loading ...