Loading ...
Loading ...
Loading ...
DTC P0217 ENGINE OVER TEMPERATURE
EC-1321
[YD (WITHOUT EURO-OBD)]
C
D
E
F
G
H
I
J
K
L
M
A
EC
On Board Diagnosis Logic EBS01208
Overall Function Check EBS01209
Use this procedure to check the overall function of the cooling fan. During this check, a DTC might not be con-
firmed.
WARNING:
● Never remove the radiator cap when the engine is hot. Serious burns could be caused by high
pressure fluid escaping from the radiator.
● Wrap a thick cloth around cap. Carefully remove the cap by turning it a quarter turn to allow built-
up pressure to escape. Then turn the cap all the way off.
WITH CONSULT-II
1. Check the coolant level in the reservoir tank and radiator.
Allow engine to cool before checking coolant level.
If the coolant level in the reservoir tank and/or radiator is below
the proper range, skip the following steps and go to EC-1323,
"Diagnostic Procedure" .
2. Confirm whether customer filled the coolant or not. If customer
filled the coolant, skip the following steps and go to EC-1323,
"Diagnostic Procedure" .
3. Turn ignition switch ON.
4. Perform “COOLING FAN” in “ACTIVE TEST” mode with CON-
SULT-II.
5. If the results are NG, go to EC-1323, "
Diagnostic Procedure" .
DTC No. Trouble diagnosis name DTC detecting condition Possible cause
P0217
Engine over temperature
(Overheat)
● Cooling fan does not operate properly (Over-
heat).
● Cooling fan system does not operate properly
(Overheat).
● Engine coolant was not added to the system
using the proper filling method.
● Engine coolant is not within the specified
range.
● Harness or connectors
(The cooling fan circuit is open or
shorted.)
● Cooling fan
● Radiator hose
● Radiator
● Radiator cap
● Water pump
● Thermostat
For more information, refer to EC-1330,
"Main 12 Causes of Overheating" .
SEF621W
SEF111X
Loading ...
Loading ...
Loading ...