Loading ...
Loading ...
Loading ...
DTC P0222, P0223 APP SENSOR
EC-1333
[YD (WITHOUT EURO-OBD)]
C
D
E
F
G
H
I
J
K
L
M
A
EC
On Board Diagnosis Logic EBS0120H
The MI will not light up for these self-diagnoses.
DTC Confirmation Procedure EBS0120I
NOTE:
If DTC Confirmation Procedure has been previously conducted, always turn ignition switch OFF and wait at
least 10 seconds before conducting the next test.
WITH CONSULT-II
1. Turn ignition switch ON.
2. Select “DATA MONITOR” mode with CONSULT-II.
3. Wait at least 5 seconds.
4. If DTC is detected, go to EC-1335, "
Diagnostic Procedure" .
91 G
Accelerator pedal position
sensor 2
[Ignition switch ON]
● Engine stopped
● Accelerator pedal: Fully released
0.4 - 0.7V
[Ignition switch ON]
● Engine stopped
● Accelerator pedal: Fully depressed
2.2 - 2.7V
92 Y
Accelerator pedal position
sensor 2 ground
[Ignition switch ON] Approximately 0.3V
TERMI-
NAL
NO.
WIRE
COLOR
ITEM CONDITION
DATA
(DC Voltage and Pulse Signal)
DTC No. Trouble diagnosis name DTC detecting condition Possible cause
P0222
Accelerator pedal position
sensor 2 circuit low input
An excessively low voltage from the APP sensor
2 is sent to ECM.
● Harness or connectors
(The APP sensor 2 circuit is open or
shorted.)
● Accelerator pedal position sensor
(Accelerator pedal position sensor 2)
P0223
Accelerator pedal position
sensor 2 circuit high input
An excessively high voltage from the APP sen-
sor 2 is sent to ECM.
SEF817Y
Loading ...
Loading ...
Loading ...