Loading ...
Loading ...
Loading ...
DTC P0011 IVT CONTROL
EC-583
[QR (WITHOUT EURO-OBD)]
C
D
E
F
G
H
I
J
K
L
M
A
EC
On Board Diagnosis Logic EBS010XW
The MI will not light up for this diagnosis.
FAIL-SAFE MODE
ECM enters in fail-safe mode when the malfunction is detected.
DTC Confirmation Procedure EBS010XX
CAUTION:
Always drive at a safe speed.
NOTE:
If DTC Confirmation Procedure has been previously conducted, always turn ignition switch OFF and wait at
least 10 seconds before conducting the next test.
TESTING CONDITION:
Before performing the following procedure, confirm that battery voltage is between 10V and 16V at
idle.
WITH CONSULT-II
1. Turn ignition switch ON and select “DATA MONITOR” mode with
CONSULT-II.
2. Start engine and warm it up to the normal operating tempera-
ture.
3. Maintain the following conditions for at least 6 consecutive sec-
onds.
Hold the accelerator pedal as steady as possible.
4. Stop vehicle with engine running and let engine idle for 10 seconds.
5. If the 1st trip DTC is detected, go to EC-587, "
Diagnostic Procedure" .
If the 1st trip DTC is not detected, go to next step.
6. Maintain the following conditions for at least 20 consecutive seconds.
INT/V SOL (B1)
● Engine: After warming up
● Shift lever: N (A/T), Neutral (M/T)
● Air conditioner switch: OFF
● No load
Idle 0% - 2%
2,000 rpm Approx. 0% - 50%
MONITOR ITEM CONDITION SPECIFICATION
DTC No.
Trouble diagnosis
name
Detecting condition Possible cause
P0011
0011
Intake valve timing
control performance
There is a gap between angle of target and
phase-control angle degree.
● Harness or connectors
(Intake valve timing control solenoid valve
circuit is open or shorted.)
● Intake valve timing control solenoid valve
● Crankshaft position sensor (POS)
● Camshaft position sensor (PHASE)
● Accumulation of debris to the signal pick-up
portion of the camshaft
Detected items Engine operating condition in fail-safe mode
Intake valve timing control The signal is not energized to the solenoid valve and the valve control does not function
ENG SPEED
1,200 - 2,000 (A constant rotation is
maintained.)
COOLAN TEMP/S 60 - 120°C (140 - 248°F)
Selector lever
M/T: Neutral position
A/T: P or N position
SEF174Y
Loading ...
Loading ...
Loading ...