Loading ...
Loading ...
Loading ...
DTC P0340 CMP SENSOR
EC-1363
[YD (WITHOUT EURO-OBD)]
C
D
E
F
G
H
I
J
K
L
M
A
EC
DTC P0340 CMP SENSOR PFP:23731
Description EBS0121L
The camshaft position sensor identifies a particular cylinder by
means of signals from the sensing plate (with five protrusions)
installed to the camshaft. The datum signal output is detected 90°
signal and sent to the ECM.
ECM Terminals and Reference Value EBS0121M
Specification data are reference values and are measured between each terminal and ground.
CAUTION:
Do not use ECM ground terminals when measuring input/output voltage. Doing so may result in dam-
age to the ECM's transistor. Use a ground other than ECM terminals, such as the ground.
: Average voltage for pulse signal (Actual pulse signal can be confirmed by oscilloscope.)
On Board Diagnosis Logic EBS0121N
MBIB0618E
TERMI-
NAL
NO.
WIRE
COLOR
ITEM CONDITION
DATA
(DC Voltage and Pulse Signal)
45 G/OR
Camshaft position sensor
power supply
[Ignition switch ON] Approximately 5.3V
47 G/R Camshaft position sensor
[Engine is running]
● Warm-up condition
● Idle speed
0 - 6V
[Engine is running]
● Warm-up condition
● Engine speed is 2,000 rpm
0 - 6V
66 G/Y
Camshaft position sensor
ground
[Ignition switch ON] Approximately 0.3V
67 —
Sensor ground
(Sensors shield circuit)
[Ignition switch ON] Approximately 0.3V
MBIB0877E
MBIB0878E
DTC No. Trouble diagnosis name DTC detecting condition Possible cause
P0340
Camshaft position sensor
circuit
Camshaft position sensor signal is not detect by
the ECM when engine is running.
● Harness or connectors
(The sensor circuit is open or
shorted.)
● Camshaft position sensor
Loading ...
Loading ...
Loading ...