Loading ...
Loading ...
Loading ...
DTC P0011 IVT CONTROL
EC-585
[QR (WITHOUT EURO-OBD)]
C
D
E
F
G
H
I
J
K
L
M
A
EC
Overall Function Check EBS011UR
Use this procedure to check the overall function of the intake valve timing control system. During this check, a
DTC might not be confirmed.
WITHOUT CONSULT-II
1. Start engine and warm it up to the normal operating temperature.
2. Turn ignition switch OFF and wait at least 10 seconds.
3. Turn ignition switch ON.
4. Set the tester probe between ECM terminal 62 (IVT control solenoid valve signal) and ground.
5. Start engine and let it idle.
6. Check the voltage under the following conditions.
Verify that the oscilloscope screen shows the signal wave as
shown below.
: Average voltage for pulse signal (Actual pulse signal can be confirmed by oscilloscope.)
7. If NG, go to EC-587, "Diagnostic Procedure" .
Conditions Voltage
AT idle
BATTERY VOLTAGE
(11 - 14V)
2,000 rpm
Approximately 4V - BATTERY VOLTAGE (11 - 14V)
SEF955V
PBIB1790E
Loading ...
Loading ...
Loading ...