Loading ...
Loading ...
Loading ...
EC-1150
[YD (WITH EURO-OBD)]
DTC P2135 APP SENSOR
On Board Diagnosis Logic EBS011EO
This self-diagnosis has the one trip detection logic.
The MI will not light up for this self-diagnosis.
DTC Confirmation Procedure EBS011EP
NOTE:
If DTC Confirmation Procedure has been previously conducted, always turn ignition switch OFF and wait at
least 10 seconds before conducting the next test.
WITH CONSULT-II
1. Turn ignition switch ON.
2. Select “DATA MONITOR” mode with CONSULT-II.
3. Wait at least 5 seconds.
4. Depress accelerator pedal slowly spending 5 seconds, and then
release it slowly spending 5 seconds.
5. If DTC is detected, go to EC-1152, "
Diagnostic Procedure" .
WITH GST
Follow the procedure “WITH CONSULT-II” above.
91 G
Accelerator pedal position
sensor 2
[Ignition switch ON]
● Engine stopped
● Accelerator pedal: Fully released
0.4 - 0.7V
[Ignition switch ON]
● Engine stopped
● Accelerator pedal: Fully depressed
2.2 - 2.7V
92 Y
Accelerator pedal position
sensor 2 ground
[Ignition switch ON] Approximately 0.3V
TERMI-
NAL
NO.
WIRE
COLOR
ITEM CONDITION
DATA
(DC Voltage and Pulse Signal)
DTC No. Trouble diagnosis name DTC detecting condition Possible cause
P2135
Accelerator pedal position
sensor 1, 2 signal correla-
tion
The correlation between APP sensor 1 signal
and APP sensor 2 signal is out of the normal
range.
● Harness or connectors
(The APP sensor circuit is open or
shorted.)
● Accelerator pedal position sensor
SEF817Y
Loading ...
Loading ...
Loading ...