Loading ...
Loading ...
Loading ...
DTC P0336 CKP SENSOR
EC-1357
[YD (WITHOUT EURO-OBD)]
C
D
E
F
G
H
I
J
K
L
M
A
EC
DTC P0336 CKP SENSOR PFP:23731
Description EBS0121C
The crankshaft position sensor monitors engine speed by means of
signals from the sensing plate (with 56 protrusions) installed to the
fly wheel. The datum signal output is detected 6° signal and sent to
the ECM. The sensor signal is used for fuel injection control and fuel
injection timing control.
CONSULT-II Reference Value in Data Monitor Mode EBS0121D
Specification data are reference values.
ECM Terminals and Reference Value EBS0121E
Specification data are reference values and are measured between each terminal and ground.
Pulse signal is measured by CONSULT-II.
CAUTION:
Do not use ECM ground terminals when measuring input/output voltage. Doing so may result in dam-
age to the ECM's transistor. Use a ground other than ECM terminals, such as the ground.
: Average voltage for pulse signal (Actual pulse signal can be confirmed by oscilloscope.)
MBIB0619E
MONITOR ITEM CONDITION SPECIFICATION
CKPS·RPM (TDC)
● Tachometer: Connect
● Run engine and compare CONSULT-II value with the tachometer indi-
cation.
Almost the same speed as the
tachometer indication.
TERMI-
NAL
NO.
WIRE
COLOR
ITEM CONDITION
DATA
(DC Voltage and Pulse Signal)
44 L/W
Crankshaft position sen-
sor power supply
[Ignition switch ON] Approximately 5.3V
46 L Crankshaft position sensor
[Engine is running]
● Warm-up condition
● Idle speed
0 - 6V
[Engine is running]
● Warm-up condition
● Engine speed is 2,000 rpm
0 - 6V
65 L/R
Crankshaft position sen-
sor ground
[Ignition switch ON] Approximately 0.3V
67 —
Sensor ground
(Sensors shield circuit)
[Ignition switch ON] Approximately 0.3V
MBIB0879E
MBIB0880E
Loading ...
Loading ...
Loading ...