Alfa-romeo 2020 Stelvio Car

User Manual - Page 215

For 2020 STELVIO.

PDF File Manual, 292 pages, Read Online | Download pdf file

2020 STELVIO photo
Loading ...
Loading ...
Loading ...
213
wait for at least 3 minutes, turn the
ignition switch in ON position without
starting the engine and wait for 20
seconds.
Procedure for reading the engine oil level
with the engine running and idling
Proceed as follows:
with the car stopped, parked on level
ground, run the engine until the second
oil temperature notch lights on the
display on the instrument panel;
idle the engine and wait at least 1
minute for the correct reading.
WARNING If the indication is not correct
after the procedure, contact an Alfa
Romeo Dealership.
WARNING The oil dipstick in the engine
compartment, on versions with 2.2 JTD
engine, must be used ONLY if the oil level
sensor is faulty. The latter condition is
indicated by the symbol which will
appear on the instrument panel.
The manual engine oil level checking
procedure must be carried out, when
necessary, on a cold engine only.
Never attempt to carry out the manual
engine oil checking procedure (using the
dipstick) with the engine hot. Contact
with the surrounding hot engine parts
could cause burns.
This operation is permitted only for the
time actually needed to restore correct
operation of the oil level sensor at an
Alfa Romeo dealership.
Engine oil consumption
78)
4)
The maximum engine oil consumption
is usually 0.88 lb (400 grams every
620 miles (1000 km). When the car is new,
the engine needs to be run in, therefore
the engine oil consumption can only be
considered stabilised after the first 3100
- 3700 miles (5000 - 6000 km).
ENGINE COOLANT
201)
79)
If the level is below the MIN mark,
remove the reservoir cap and top up
with suitable fluid (see the "Fluids and
lubricants" paragraph in the "Technical
data" chapter), until it reaches the MAX
mark.
WARNING Never attempt to remove the
cap with radiator or expansion tank hot:
DANGER OF SCALDING!
WINDSCREEN/HEADLIGHT WASHER
FLUID
202) 203)
The windscreen and headlights washer
fluid reservoir (where available) is
equipped with a telescopic filler.
If the level is low, remove the reservoir
cap (4) fig.220 andthen liftthefiller,
as shown in the figure, and add the
fluid described in the "Technical
Specifications" chapter. After having
topped up the fluid, arrange the filler
correctly and then press on the cap until
you hear it click.
220 09086S0666EM
NOTE The headlight washers are
activated every 10 activations of the
windscreen washer.
WARNING With a low fluid level
(indicated by the dedicated symbol
appearing on the instrument panel
Loading ...
Loading ...
Loading ...