Loading ...
Loading ...
Loading ...
IN AN EMERGENCY
186
position the jack(4) fig.201 under
the car, near the wheel to be changed,
taking care not to damage the plastic
aerodynamic guard;
lift the extension lever (2) on the
wrench (3);
201 08066V0013EM
turn the extension lever (2) clockwise
until the round pin on the jack engages in
the hole in the lifting block located about
15 cm from the outside edge of the body.
Thelifting points(5) are shown infig.201
and are marked by a triangle on the
aerodynamicspoiler fig.202;
202 09056V0001EM
warn anybody nearby that the car is
about to be raised;
they should stay clear and they should
be warned not to touch the car until it is
back on the ground;
turn the extension lever (2) until the
wheel is a few centimetres off the
ground;
remove the five wheel fastening bolts
and take the wheel off;
make sure the contact surfaces
between space-saver wheel and hub are
clean so that the fastening bolts will not
come loose;
fit the space-saver wheel by inserting
the first bolt for two threads into the
hole closest to the valve;
take the wrench (3) and fully tighten
the fixing bolts;
inflate the space-saver wheel by
removing the cap from its inflation valve
and screwing on the compressor inflation
hosefitting(6) fig.203;
make sure that the switch (8) on the
compressor (6) is in the (0) (off) position,
open the rear hatch and insert the plug
into the power socket in the luggage
compartment or on the central tunnel
and start the engine. Put the switch (8) in
the (I) (on) position;
inflate the space-saver wheel to a
pressure of 43.5 psi (3 bar);
203 08066V0011EM
WARNING To conserve the battery
charge, it is recommended to leave the
vehicle running for the entire inflation
process.
To obtain a more accurate reading, it is
advisable to check the pressure of the
space-saver wheel on the pressure gauge
(7) with the compressor off.
Loading ...
Loading ...
Loading ...