Loading ...
Loading ...
Loading ...
VDL (E3.1) 10/2020 Page 54/196
Following each new tightening of an expansion rack, check that the lateral parts of the rack fit
closely over their whole surface to the inner chamber wall. This is necessary in order to en-
sure the specified temperature exactitude.
NOTICE
Risk of invalid calibration due to modified heat transmission when changing be-
tween aluminum and stainless-steel racks.
Undefined heating behavior.
∅ Do NOT change between aluminum and stainless-steel racks
∅ Use the supplied expansion racks only.
6.2 Mounting the pressure regulator
The pressure regulator is included with the chamber and must be mounted on the chamber rear
Accessory pack for mounting the pressure regulator
(a) pressure regulator
(b) tube
(c) 6 screws
(d) brass nozzle for compressed air connection
(e) bracket
(f) cable connector
(g) 2 nuts
for the bolts with thread on the chamber rear
Connections on the chamber rear as supplied
(h) hole for the cable connection
(i) 2 bolts with thread
(a)
(b)
(d)
(c)
(e)
(f)
(g)
(h)
(i)
(i)
Loading ...
Loading ...
Loading ...