Loading ...
Loading ...
Loading ...
VDL (E3.1) 10/2020 Page 161/196
24. Options
24.1 APT-COM™ 4 Multi Management software (option)
The chamber is regularly equipped with an Ethernet interface (2) that can connect the BINDER APT-COM™
4 Multi Management Software.
The MAC Address is indicated in the “Device info” controller menu (chap. 20.1.2).
The actual temperature and pressure values are given at adjustable intervals. Programming can be per-
formed graphically via PC.
Up to 100 chambers can be cross-linked. For further information please refer to the APT-COM™ 4 operat-
ing manual.
24.2 Analog outputs for temperature and pressure (option)
With this option, the camber is equipped with analog outputs 4-20 mA for temperature and pressure. These
outputs allow transmitting data to external data registration systems or devices.
A 2-meter connection cable is firmly connected to the connection “Analog output” (3b) located in the VDL
rear connection panel. The connection of this cable is realized as a 9-poles SUB-D socket as follows:
ANALOG OUTPUT 4-20 mA DC
PIN 1: Temperature +
PIN 2: Temperature –
PIN 4: Pressure +
PIN 5: Pressure –
Temperature range: 0 °C to +110 °C, pressure range: 0 mbar to 1100 mbar
F
igure 27: Connection cable
on the “Analog output” (3b) connection
Figure 28: SUB-D socket
for the analog outputs option
A suitable plug is enclosed. Please note that the plug connection of the analog output is unprotected and
must therefore be established outside a zone.
DANGER
Explosion hazard due to sparking when disconnecting an electrical connection.
Serious injury or death from burns and / or explosion pressure.
Make sure that the plug connection of the analog output is located outside a zone.
Make sure that the plug connection of the analog output is located outside the installa-
tion area of the VDL and the pump. Take into account the information on zone classifi-
cation (chap. 3.5.2)
(3b)
Loading ...
Loading ...
Loading ...