Loading ...
Loading ...
Loading ...
VDL (E3.1) 10/2020 Page 143/196
18.7.7 Saving the time program
Section view (sample values).
After the all desired values of the program
section have been configured, press the Con-
firm icon to take over the programming.
The controller changes to the program view.
Program view (sample program).
Press the Confirm icon to take over the pro-
gramming.
The controller changes to the Normal display.
To save the programming it is absolutely required to press the Confirm icon. Otherwise all
settings will be lost! There is no confirmation prompt!
19. Week programs
The MB2 program controller permits programming week programs with real-time reference. It offers 5 week
program places in total with up to 100 shift points for each week program.
Path: Main menu > Programs> Week program
For each program section you can enter the moment in time, the temperature set-point, the pressure set-
point, and the switching states of the special controller functions.
Before starting the program, check the set-points entered in fixed value mode. After the end
of the program, the set-points will equilibrate to these values.
Solvents and forming vapors can ignite if the drying temperature is too high
DANGER
Fire and explosion hazard when exceeding the auto-ignition temperature of the sol-
vent due to excess drying temperature.
Serious injury or death from burns and / or explosion pressure.
Make sure that only solvents with an auto-ignition temperature that is higher than
200 °C / 392 °F may be entered into the chamber. Check the auto-ignition temperature
with the safety specifications of the solvent. In the case of solvent mixtures, use the
auto-ignition temperature of the material with the lowest auto-ignition temperature.
Loading ...
Loading ...
Loading ...