Loading ...
Loading ...
Loading ...
2-52 PERIODIC MAINTENANCE
Periodic Maintenance Procedures
•
Replace the fluid seal [A] with a new one.
Apply silicone grease to the fluid seal, and install it into
the cylinder by hand.
•
Replace the dust seal [B] with a new one.
Apply silicone grease to the dust seal, and install it into
the cylinder by hand.
•
Install the pad spring [A] in the caliper as shown.
•
Apply brake fluid to the outside of the piston [B], and push
it into the cylinder by hand.
•
Replace the friction boot [C] and dust boot [D].
•
Apply a silicone grease to the caliper holder shafts [A].
•
Check that the guide [B] is in place on the caliper holder.
•
Assemble the caliper and the caliper holder.
•
Install the pads (see Rear Brake Pad Installation in the
Brakes chapter).
•
Wipe up any spilled brake fluid on the caliper with wet
cloth.
Brake Pad Wear Inspection
•
Remove the brake pads (see Front/Rear Brake Pad Re-
moval in the Brakes chapter).
•
Check the lining thickness [A] of the pads in each caliper.
If the lining thickness of either pad is less than the service
limit [B], replace both pads in the caliper as a set.
Front Brake Pad [C]
Rear Brake Pad [D]
Pad Lining Thickness
Standard:
Front
4.0 mm (0.16 in.)
Rear
5.0 mm (0.20 in.)
Service Limit: 1 mm (0.04 in.)
Loading ...
Loading ...
Loading ...