Loading ...
Loading ...
Loading ...
ENGINE LUBRICATION SYSTEM 7-13
Oil Pump
•
Pack grease into the cavity [A] between the inner rotor
and outer rotor for improve the oil pump initial priming.
•
Install the dowel pin [B].
•
Install the oil pump cover [C] so that the dowel pin fits into
the hole [D] of the oil pump cover.
•
Install the water pump (see Water Pump Installation in the
Cooling System chapter).
Oil Pump Drive Gear Removal
•
Remove:
Clutch (see Clutch Removal in the Clutch chapter)
Oil Pan (see Oil Pan Removal)
Circlip [A] and Washer [B]
Special Tool - Outside Circlip Pliers: 57001-144
•
Remove:
Oil Pump Drive Gear [A]
Washer [B]
Oil Pump Drive Gear Installation
•
Apply molybdenum disulfide oil solution to the hole of the
oil pump drive gear shaft in the crankcase.
•
Apply molybdenum disulfide grease to the journal portion
[A] on the oil pump drive gear shaft [B].
•
Install the washer [C] to the shaft.
•
Replace the circlip [A] with a new one.
•
Insert the oil pump drive gear to the lower crankcase.
•
Install the washer [B] and circlip.
Special Tool - Outside Circlip Pliers: 57001-144
•
Fit the projection on the shaft and oil (water) pump shaft
slot.
•
Set the circlip to the original position.
Loading ...
Loading ...
Loading ...