Loading ...
Loading ...
Loading ...
SUSPENSION 13-29
Swingarm
•
Tighten the swingarm pivot shaft nut.
Torque - Swingarm Pivot Shaft Nut: 108 N·m (11.0 kgf·m,
79.7 ft·lb)
•
Move the swingarm up and down to check for abnormal
friction.
•
Install the removed parts (see appropriate chapters).
Swingarm Bearing Removal
•
Remove:
Swingarm (see Swingarm Removal)
Collar [A]
Grease Seals [B]
Sleeve [C]
Circlip (Right Side) [D]
Special Tool - Inside Circlip Pliers: 57001-143
•
Remove the ball bearing and needle bearings.
Special Tool - Oil Seal & Bearing Remover [A]: 57001-1058
Swingarm Bearing Installation
•
Replace the needle bearings [A], ball bearing [B], grease
seals [C] and circlip [D] with new ones.
•
Install the needle bearings, ball bearing, grease seals and
circlip as shown.
Left Side [E]
Right Side [F]
9.5 mm (0.37 in.) [G]
29.5 mm (1.16 in.) [H]
NOTE
○
Install the needle and ball bearings so that the marked
side faces out.
Special Tool - Needle Bearing Driver,
28: 57001-1610
Press in the ball bearing until it bottomed.
Special Tool - Bearing Driver Set: 57001-1129
Install the circlip.
Special Tool - Inside Circlip Pliers: 57001-143
Press in the grease seals so that seal surface is flushed
with the end of housing.
Special Tool - Bearing Driver Set: 57001-1129
Loading ...
Loading ...
Loading ...