Loading ...
Loading ...
Loading ...
STEERING 14-7
Steering Stem
•
Pushing up the stem base, and remove the steering stem
nut [A].
Special Tool - Steering Stem Nut Wrench [B]: 57001-1100
•
Remove:
Steering Stem
Stem Cap [C]
Upper Ball Bearing Inner Race and Ball Bearing
•
To remove the ball bearing outer races [A] pressed into
the head pipe [B], insert a bar [C] into the recesses of
head pipe, and applying it to both recesses alternately
hammer it to drive the race out.
NOTE
â—‹
If either steering stem bearing is damaged, it is recom-
mended that both the upper and lower bearings (includ-
ing outer races) should be replaced with new ones.
•
Remove the lower ball bearing from the steering stem.
•
Remove the lower ball bearing inner race (with its oil seal)
[A] which is pressed onto the steering stem with a suitable
commercially available chisel [B].
Stem, Stem Bearing Installation
•
Replace the bearing outer races with new ones.
•
Drivethemintotheheadpipeatthesametime.
Special Tools - Head Pipe Outer Race Press Shaft [A]:
57001-1075
Head Pipe Outer Race Driver,
54.5 [B]:
57001-1077
Head Pipe Outer Race Driver,
55: 57001
-1446
•
Apply grease to the outer races.
•
Replace the bearing inner races and oil seal with new
ones.
•
Apply grease to the oil seal.
•
Install the oil seal [A] on the steering stem.
•
Apply grease to the stem and hammer the lower ball bear-
ing inner race [B].
Special Tools - Steering Stem Bearing Driver,
42.5 [C]:
57001-1344
Steering Stem Bearing Driver Adapter,
41.5 [D]: 57001-1345
Loading ...
Loading ...
Loading ...