Loading ...
Loading ...
Loading ...
11-10 FINAL DRIVE
Sprocket, Coupling
Engine Sprocket Removal
•
Remove:
Engine Sprocket Cover Bolts [A]
Engine Sprocket Cover [B]
•
Flatten out the bended washer [A].
•
Remove the engine sprocket nut [B] and washer.
NOTE
○
When loosening the engine sprocket nut, hold the rear
brake on.
•
Raise the rear wheel off the ground with the stand.
•
Loosen the drive chain (see Drive Chain Slack Adjust-
ment in the Periodic Maintenance chapter).
•
Remove the drive chain from the rear sprocket toward the
right.
•
Disengage the drive chain [A] from the engine sprocket
[B].
•
Pull the engine sprocket off the output shaft [C].
Engine Sprocket Installation
•
Replace the sprocket washer.
•
Install the engine sprocket so that “OUT SIDE” letters [A]
face outward.
•
Apply molybdenum disulfide oil solution to the threads
and the seating surface of the engine sprocket nut.
•
Tighten:
Torque - Engine Sprocket Nut: 125 N·m (12.7 kgf·m, 92.2
ft·lb)
NOTE
○
Tighten the engine sprocket nut while applying the rear
brake.
•
After torquing the engine sprocket nut, bend the one side
of the washer over the nut.
•
Adjust the drive chain slack after installing the engine
sprocket (see Drive Chain Slack Adjustment in the Pe-
riodic Maintenance chapter).
Loading ...
Loading ...
Loading ...