Loading ...
Loading ...
Loading ...
3-118 FUEL SYSTEM (DFI)
Fuel Pump
Fuel Pump Installation
•
Remove dirt or dust from the fuel pump [A] by lightly ap-
plying compressed air.
•
Replace the fuel pump gasket with a new one.
NOTE
â—‹
Be careful not to bend the fuel level sensor arm.
•
Check that the fuel pump terminal [A] and band [B] are in
place.
•
Apply a non-permanent locking agent to the threads of
the fuel pump bolts.
•
Tighten the fuel pump bolts [C] to a snug fit.
•
Tighten the fuel pump bolts alternating diagonally.
Torque - Fuel Pump Bolts: 9.8 N·m (1.0 kgf·m, 87 in·lb)
•
Tighten the pump bolts again to check the tightness.
Fuel Pump Operation Inspection
NOTE
â—‹
Be sure the battery is fully charged.
•
Turn the engine stop switch to run position.
•
Turn the ignition switch on and make sure that the fuel
pump operates (make light sounds) for 3 seconds, and
then stops.
•
Turn the ignition switch off.
If the pump does not operate as described above, check
the operating voltage (see Fuel Pump Operating Voltage
Inspection).
Loading ...
Loading ...
Loading ...