Loading ...
Loading ...
Loading ...
9-26 CRANKSHAFT/TRANSMISSION
Balancer
Balancer Removal
•
Split the crankcase (see Crankcase Splitting).
•
Remove:
Oil Seal [A]
Balancer [B]
Balancer Installation
•
Check that the rubber dampers [A] are in place as shown.
•
Apply molybdenum disulfide oil solution to the damper
contact portions of the balancer weight [A].
•
Install the balancer weight into the gear [B].
Align the punch mark [C] of the balancer weight with the
groove [D] of the gear.
•
Apply molybdenum disulfide oil solution to the needle
bearings. Insert the needle bearings.
•
Fit the washers [A] on both ends of the weight and gear
assembly. The projected sides [B] face inward.
•
Insert the pin [A] as shown.
•
Set the balancer on the upper crankcase half.
Align the punch mark [B] on the balancer gear [C] with the
mark [D] on the balancer drive gear [E] of crankshaft.
Loading ...
Loading ...
Loading ...