Loading ...
Loading ...
Loading ...
PROBLEM CAUSE SOLUTION
Handwheel is hardtoturnor I. Sawdust hascollectedon the I. Remove handwheel;clean end
columnbinds, elevating shaft, lubricatethe shaft.
2, Columnis outof alignment. 2. See Adjustingthe Column
Tubein Assemblysection.
Saw burnsor scores edges of 1. Columntube istoo looseinthe 1. See Adjustingthe Column
woodin cut. columnsupport, Tubein Assemblysection,
2. Blade orteeth are bentor dull.
2. Sharpen or replacethe blade.
See the removalprocedurein
Assemblysection.
3. Bladeisout of alignment.
3. Use bladealignmentproce-
duresin Adjustmentsection.
4. Wrongblade isbeing used.
4. Change blade. See the removal
procedurein Assemblysection.
5, Board iswarped.
5. Replacethe board.
6. Arm is loose or miseligned.
6. See SettingtheArm Lock
Wheelin theAssemblysection.
7. Yoke islooseon carriage.
7. See Settingthe Yoke Clamp
procedurein Assemblysection.
Bevel cutsare nottrue.
8. Arm isout of alignment, 8.
9. Work Is being fed toofast. 9.
1. Bevel lock lever isloose, 1.
See AligningArm for Cross
Cuts in Adjustmentssection.
Feed workintoblade slower.
See SettingtheBevel Lock
Leverin Assemblysection.
2. Blade is notperpendicularto
table top.
3. Columntube istoo loose inthe
columnsupport.
4. Table top isnot paraUeltothe
arm.
2. See Aligningthe Blade tothe
Tablein Adjustmentssection.
3. See Adjustingthe Column
Tubein Assemblysection.
4. See LevelingTable Supports
and Levelingthe Front Tablein
the Assemblysection,
5, Yoke islooseon carriage,
5, See Settingthe YokeClamp
procedurein Assemblysection.
6. Arm isout ofalignment.
6. See AligningArm for Cross
Cuts inAdjustmentssection.
57 CRAFTSHIIN'RADIALSAW315.220380
Loading ...
Loading ...
Loading ...