Loading ...
Loading ...
Loading ...
PROBLEM CAUSE SOLUTION
Saw vibmtas excessively. I. Bladeis warped.
1, Replacethe blade. See the
removalprocedurein Assembly
section,
2. Saw isnot mountedsecurely, 2, Tightenall hardware.
3. Worksurface is uneven.
3. Reposition on a flat surface.
Adjust the leveling feet on legs.
Saw isnoisywhen running.
1. Motor needs attention.
1. Have the motorcheckedat
yournearest Sears Service
Center.
Carriage does nottravel smoothly
in track underarm.
1. Track is dirtyor sticky.
1. Clean track. See Installing
CarriageAssemblyin Assem-
bly section.
2. Carriagebeadngs are bad.
2. Replacecerdage bearings.
Contactyour nearestSears
servicecenter.
3. Bladeor teeth are dull or bent.
3. Sharpen or replacethe blade.
See the removalprocedurein
Assemblysection.
4. Blade isout ofalignment. 4. Use bladealignmentproce-
duresin Adjustmentsection.
5. Boardiswarped. 5. Replace the board,
Saw stallswhen dpping.
1. Bladeor teeth are dull orbent.
1. Sharpen or replacethe blade.
See the removalprocedurein
Assemblysection.
2. Fence isnot straight. 2. Check withsquare;sand or
replace.
3. Work isbeing fedtoo fast. 3. Feed workintobladeslower.
4. Wrong bladeis being used. 4. Change the blade.
5. Columntube is too looseinthe
columnsupport.
5. See Adjustingthe Column
Tubein Assemblysection.
6. Arm ismisalignedor loose. 6. See Settingthe Arm Look
Wheelinthe Assemblysection.
7. Yoke is loose on carriage. 7, See Settingthe YokeClamp
procedurein Assemblysection,
8. Sawdust has accumulated
between tables.
8. Remove and clean tables.
I:HFt'$NIUr RADIALSAW315.220380 56
Loading ...
Loading ...
Loading ...