Loading ...
Loading ...
Loading ...
GETTING TO KNOW YOUR VEHICLE 89
CLOSING THE HOOD
LIFTGATE
TO UNLOCK/OPEN THE LIFTGATE
The power liftgate may be opened by
pushing the liftgate button on the key
fob or by pushing the electronic liftgate
release button.
Push the liftgate button on the key fob twice
within five seconds to open the power liftgate.
Once the liftgate is open, pushing the button
twice within five seconds a second time will
close the liftgate.
With a valid Passive Entry key fob within 5 ft
(1.5 m) of the liftgate, push the Passive Entry
button located to the left of the electronic
liftgate release button to lock the liftgate and
doors.
Liftgate Entry
NOTE:
When you push the electronic liftgate release
button, either only the liftgate will unlock, or all
the doors and the liftgate will unlock, depending
on the selected setting in the Uconnect system
Ú page 207.
NOTE:
Use the power door lock switch on either
front door trim panel or the key fob to lock
and unlock the liftgate.
The driver's door lock cylinder will not lock or
unlock the liftgate.
NOTE:
The liftgate can also be opened manually by
pushing the electronic liftgate release button
and pulling upward in one fluid motion.
WARNING!
Be sure the hood is fully latched before
driving your vehicle. If the hood is not fully
latched, it could open when the vehicle is in
motion and block your vision. Failure to follow
this warning could result in serious injury or
death.
CAUTION!
To prevent possible damage, do not slam the
hood to close it. Lower hood to approximately
12 inches (30 cm) and drop the hood to
close. Make sure hood is fully closed for both
latches. Never drive vehicle unless hood is
fully closed, with both latches engaged.
1 — Passive Entry Button
2 — Electronic Liftgate Release Button
WARNING!
Driving with the liftgate open can allow
poisonous exhaust gases into your vehicle.
You and your passengers could be injured by
these fumes. Keep the liftgate closed when
you are operating the vehicle.
2
21_WL_OM_EN_USC_t.book Page 89
Loading ...
Loading ...
Loading ...