Loading ...
Loading ...
Loading ...
128 STARTING AND OPERATING
The parking brake will automatically engage if
all of the following conditions are met:
The vehicle is at a standstill.
There is no attempt to press the brake pedal
or accelerator pedal.
The seat belt is unbuckled.
The driver door is open.
SafeHold can be temporarily bypassed by
pushing the EPB switch while the driver door is
open. Once manually bypassed, SafeHold will
be enabled again once the vehicle reaches
12 mph (20 km/h) or the ignition is turned to
the OFF position and back to ON again.
HOLD ‘N GO— IF EQUIPPED
Hold ‘N Go is a comfort feature that allows the
driver to remove their foot from the brake pedal
once the vehicle has come to a stop. The vehicle
must be held at a standstill for a predetermined
amount of time by hydraulic braking. The EPB
will then engage and continue to hold the
vehicle at a stop until the driver applies the
accelerator pedal. Hold ‘N Go can be activated
or deactivated by pushing the HOLD button
located on the switch bank.
HOLD Switch
The following conditions must be met for Hold
‘N Go to activate:
Driver’s door closed
Driver's seat belt fastened
Vehicle is at a standstill
Forward gear is selected
ACC is not engaged
EPB is not applied
ParkSense Active Park Assist System auto
parking maneuver is not activated
BRAKE MAINTENANCE MODE
We recommend having your brakes serviced by
an authorized dealer. You should only make
repairs for which you have the knowledge and
the right equipment. You should only enter
Brake Maintenance Mode during brake service.
When servicing your rear brakes, it may be
necessary for you or your technician to push the
rear piston into the rear caliper bore. With the
EPB system, this can only be done after
retracting the EPB actuator. Fortunately,
actuator retraction can be done easily by
entering the Brake Maintenance Mode through
the Uconnect Settings in your vehicle. This
menu based system will guide you through the
steps necessary to retract the EPB actuator in
order to perform rear brake service.
Maintenance Mode has requirements that must
be met in order to be activated:
The vehicle must be at a standstill.
The parking brake must be unapplied.
The transmission must be in PARK or
NEUTRAL.
While in Maintenance Mode, the EPB fault lamp
will flash continuously while the ignition is ON.
21_WL_OM_EN_USC_t.book Page 128
Loading ...
Loading ...
Loading ...