Loading ...
Loading ...
Loading ...
170 STARTING AND OPERATING
rately. This is due to the system’s dynamic
vehicle calibration to improve the perfor-
mance of the feature. The system will also
continuously perform the dynamic vehicle
calibration to account for differences such as
over or under inflated tires and new tires.
ENABLING AND DISABLING THE
P
ARKSENSE ACTIVE PARK ASSIST
S
YSTEM
The ParkSense Active Park Assist
system can be enabled and disabled
with the ParkSense Active Park Assist
switch, located on the switch panel
above the Uconnect display.
To enable or disable the ParkSense Active Park
Assist system, push the ParkSense Active Park
Assist switch once (LED turns on). Pushing the
switch a second time will disable the system
(LED turns off).
The ParkSense Active Park Assist system will
turn off automatically for any of the following
conditions:
Parking maneuver is completed
Vehicle speed is greater than 18 mph
(30 km/h) when searching for a parking
space
Vehicle speed is greater than 5 mph
(7 km/h) during active steering guidance into
the parking space
Steering wheel is touched during active
steering guidance into the parking space
ParkSense Front and Rear Park Assist switch
is pushed
Driver's door is opened
Rear liftgate is opened
Electronic Stability Control/Anti-Lock Braking
System intervention.
The ParkSense Active Park Assist system allows
a maximum number of shifts between DRIVE
and REVERSE. If the maneuver cannot be
completed within the maximum amount of
shifts, the system will cancel and the
instrument cluster display will instruct the driver
to complete the maneuver manually.
The ParkSense Active Park Assist system will
only operate and search for a parking space
when the following conditions are present:
Gear selector is in DRIVE
Ignition is in the RUN position
ParkSense Active Park Assist switch is acti-
vated
Driver's door is closed
Rear liftgate is closed
Vehicle speed is less than 15 mph (25 km/h)
NOTE:
If the vehicle is driven above approximately
15 mph (25 km/h), the instrument cluster
display will instruct the driver to slow down. If the
vehicle is driven above approximately 18 mph
(30 km/h), the system will cancel. The driver
must then reactivate the system by pushing the
ParkSense Active Park Assist switch.
The outer surface and the underside of the
front and rear fascias/bumpers are clean
and clear of snow, ice, mud, dirt or other
obstruction.
When pushed, the LED on the ParkSense Active
Park Assist switch will blink momentarily, and
then the LED will turn off if any of the above
conditions are not present.
If the vehicle is in any other gear than DRIVE,
and an objected is detected, the system will
default to Parallel Park Exit. A prompt will
appear in the radio screen, and the driver will
need to select “Yes” or “No” for a Parallel Park
Exit maneuver. Any other conditions will result
in a default to a Parallel Parking maneuver.
21_WL_OM_EN_USC_t.book Page 170
Loading ...
Loading ...
Loading ...