Loading ...
Loading ...
Loading ...
180 STARTING AND OPERATING
The TrailCam system has programmable
settings that may be selected through the
Uconnect system Ú page 207.
Manual Activation Of The TrailCam
TrailCam view can be activated via the below
methods:
Press the “FWD Camera” button on the
controls screen.
Press the “Forward Facing Camera” button
on the apps menu.
Press the “TrailCam” button on the Off-Road
Pages.
Select “Auto Launch Off Road+” (if equipped)
under camera settings while the “Off Road+”
button is pushed.
The TrailCam view can also be activated by
pressing the icon on the Backup Camera
view. The Backup Camera view can also be
activated by pressing the icon on the
TrailCam view.
When the vehicle is shifted out of REVERSE
(with Camera Delay turned off) and TrailCam
view is active, the TrailCam mode is exited and
the previous screen appears again.
When the vehicle is shifted out of REVERSE
(with Camera Delay turned on) and the TrailCam
view is active, the TrailCam image will be
displayed for up to 10 seconds unless the
vehicle speed exceeds 8 mph (13 km/h), the
transmission is shifted into PARK, the ignition is
placed in the OFF position, or the touchscreen
button “X” to disable display of the TrailCam
view is pressed.
NOTE:
If the vehicle speed remains below 8 mph
(13 km/h) while in 2WD or 4WD High, the
TrailCam image will be displayed continu-
ously until deactivated via the touchscreen
button “X”, the transmission is shifted into
PARK, or the ignition is placed in the OFF
position.
The touchscreen button “X” to disable the
display of the camera image is made avail-
able ONLY when the vehicle is not in
REVERSE.
The TrailCam view will stay active regardless
of the vehicle speed and time while in 4WD
Low.
Cleaning The TrailCam
Press and hold the Clean Camera soft button
located on the TrailCam view to wash the
TrailCam. Washer fluid will stop when the
button is released.
The camera can be washed up to 20 seconds
at a time while holding the button.
The Clean Camera system is not available
when windshield washing is in process.
NOTE:
Pressing the Clean Camera soft button will
also wash the Night Vision camera (if
equipped).
If the front window washer feature is acti-
vated, all of the front cameras on the vehicle
will be washed as well. The front camera
washers will not operate when the low
washer fluid warning is displayed.
When enabled, active dynamic Tire Lines are
projected on the ground plane of the TrailCam
view based on the steering wheel position.
21_WL_OM_EN_USC_t.book Page 180
Loading ...
Loading ...
Loading ...