Loading ...
Loading ...
Loading ...
Help with parking and manoeuvring
●
R
ear side area: 0.60 m
Screen display
The image displayed represents the super-
vised zones in several segments. As the vehi-
cle approaches an obstacle, it approaches
the displayed vehicle segment
›››
Fig. 273
B
and
›
››
Fig. 274
B
. Ultimately, when the sec-
ond-t
o-last segment is shown, the collision
area has been reached. Stop the vehicle!
Segment colours (colour screen)
The distance to the obstacle ahead is
approximately 31-120 cm and 31-160
cm behind. The audio signal is intermit-
tent.
The distance to the obstacle ahead or
behind is approximately 0-30 cm. The
audio signal is continuous.
1)
With trailer
A specific image is displayed on the screen of
vehicles with a factory-fitted towing bracket
and an electrically connected trailer. In this
case, the distances behind the vehicle are not
indicated.
Yellow
Red
Switching the parking sensor system
sound on and off
If the button on the infotainment system
display is pressed briefly, it may mute the
sound of OPS warnings. To switch the warn-
ings back on, press the button again briefly.
When the OPS is switched off and back on
again, muting is cancelled. Error messages
cannot be switched off.
WARNING
Do not be distracted from the traffic when
l
ooking at the screen.
Reverse Assist (Rear View
Camer
a)
Introduction
The camera fitted to the rear lid helps drivers
during parking or r
eversing manoeuvres
›››
page 263. The camera image and certain
orientation points generated by the system
are indicated on the factory-fitted infotain-
ment system screen.
Two types of location point (modes) can be
selected:
●
Mode 1: reverse parking perpendicular to
the road (e.g. in a car park).
●
Mode 2: reverse parking parallel to the
curb.
The mode can be changed by pressing the
button on the infotainment system screen.
Only the mode to which the points can be
changed will be displayed.
WARNING
Use of the camera to calculate the dis-
t
ance from obstacles (people, vehicles,
etc.) is inaccurate and may cause acci-
dents and severe injuries.
●
The camera lens expands and distorts
the field of vision and displays the objects
on the screen in a different, vague manner.
●
Some objects may not be displayed or
may not be very clear (e.g. very thin posts
or fences), due to the resolution of the
monitor or if the light is dim.
●
The camera has blind spots in which ob-
stacles and people are not detected.
●
Keep the camera lens clean and clear of
snow and ice. Do not cover it.
»
1)
The permanent sound starts at a somewhat
gr
eater distance on vehicles with a factory-fitted
towing bracket.
297
Loading ...
Loading ...
Loading ...