Loading ...
Loading ...
Loading ...
Blower Control
Blower Control regulates the amount of air
forced through the Climate Control system.
Adjusting the blower will cause automatic
mode to switch to manual operation. There
are seven blower speeds available. The speeds can be
selected using either the blower control knob on the
faceplate o r the buttons on the touchscreen.
•
Faceplate: The blower speed increas es as you turn
the blower control knob clockwise from the lowest
blower setting. The blower speed decreases as you
turn the blower control knob counterclockwise.
•
Touchscreen: Use the small blower icon to reduce
the blower setting and the large blower icon to
increase the blower setti ng. The blower can also be
selected by pressing the blower bar area between
the icons.
Mode Control
Select one of the Mode buttons on the
touchscreen or press the Mode button on
the faceplate to adjust the airflow distribu-
tion. The airflow distribution can be adjusted
so air come s from the instrument panel outlets , floor
outlets, defrost outlets, and demist outlets.
Panel Mode
Air comes from the outlets in the instr ume nt
panel. Each of these outlets can be individu-
ally adjusted to direct the flow of air. The air
vanes of the center outlets and outboard
outlets can be moved up and down or side to side to
regulate airflow direction. There is a shut-off wheel
located below the air vanes to shut off or adjust the
amount of ai rflow from these outlets.
Bi-Level Mode
Air comes from the instrument panel outlets
and floor o ut let s. A slight amount of air is
directed through the defrost and side win-
dow demister outlets.
NOTE:
Bi-Level mode is designed under comfort conditions to
provide cooler air out of the panel outlets and warmer
air from the f loo r outlets.
Floor Mode
Air comes from the floor ou tle ts. A slight
amount of ai r is directed through the defrost
and side wi ndow demister outlets.
Mix Mode
Air is di re cted through the floor, defrost, and
side window demister outlets. This setting
works best in cold or snowy conditions that
require extra heat to the windshield. This
setting is go od for maintaining comfort while reducing
moisture on the windshield.
Climate Control OFF Button
Press and rele ase the OFF button on the
touchscreen, or push the OFF button on the
faceplate to turn the Climate Control
ON/OFF.
AUTOMATIC TEMPERATURE
CONTROL (ATC) — IF EQUIPPED
Automatic Operation
1. Push the AUTO button on the faceplate, or the AUTO
button on the touchscreen on the Automatic Tem-
perature Control (ATC) Panel.
2. Next, adjust the temperature that you would like the
system to maintain by adjusting the driver and pas-
senger temperature control buttons. Once the
desired temperature is displayed, the system will
achieve and automatically maintain that comfort
level.
3. When the system is set up for your comfort level, it
is not necessary to change the settings. You will
experience the greatest efficiency by simply allowing
the system to function automatically.
NOTE:
•
It is not necessary to move the temperature settings
for cold or hot vehicles. The system automatically
adjusts the temperature, mode, and blower speed
to provide comfort as quickly as possible.
•
The temperature can be displayed in US or Metric
units by selecting the US/Metric customer-
programmable feature within Uconnect Settings
page 201.
To provide you with maximum comfort in the Automatic
mode during cold start-ups, the blower fan will remain
on low until the engine warms up. The blower will
increase in speed and tra nsiti on into Auto mode.
76 GETTING TO KNOW YOUR VEHICLE
Loading ...
Loading ...
Loading ...