User Manual - Page 138

For 2024 JEEP WRANGLER.

Loading ...
Loading ...
Loading ...
Seat Belt Reminder Warning Light
This warning light indicates when the driver
or passenger se at belt is unbuckled. When
the ignition i s first placed in the ON/RUN or
ACC/ON/RUN position and if the driver’s
seat belt is unbuckled, a chime will sound and the light
will turn on. When driving, if the driver or front passen-
ger seat belt remains unbuckle d, the Seat Belt
Reminder Light will flash or re main on continuou sly and
a chime will sound
page 239.
Swing Gate Open Warning Light
This warning light will illuminate when the
swing gate is open.
NOTE:
If the vehicle is moving, there will also be a single chime.
Torque Limited Warning Light
PHEV Only
This warning light illuminates when vehicle
acceleration is limited due to a reduction in
engine or e lect ric motor performance. Con-
tact an autho ri zed dealer for service if illumi-
nation persists.
Transmission Temperature Warning Light
This warning light will illuminate to warn of a
high transmission fluid temperature. This
may occur with strenuous usage such as
trailer towing. If this light turns on, stop the
vehicle and run the engine at idle or slightly faster, with
the transmission in PARK (P) or NEUTRAL (N), until the
light turns off. Once the light turns off, you may con-
tinue to drive normally.
WARNING!
If you continue operating the vehicle when the Trans-
mission Temperature Warning Light is illuminated you
could cause the fluid to boil over, come in contact
with hot engine or exhaust components and cause a
fire. If you continue to operate the vehicle when the
“CLUTCH HOT” message is displayed, or the Transmis-
sion Temperature Warning Light is illuminated, you
could cause the clutch to overheat and cause a fire.
CAUTION!
Continuous driving with the Transmission Tempera-
ture Warning Light illuminated will eventually cause
severe transmission damage or transmission failure.
If you continue to operate the vehicle when the
“CLUTCH HOT” message is displayed, or the Transmis-
sion Temperate Warning Light is illuminated, you
could cause the clutch to overheat and cause severe
clutch damage, t ransmi ssio n damage, or failure.
Vehicle Security Warning Light
If Equipped
This light will flash at a fast rate for approxi-
mately 15 seconds when the Vehicle Secu-
rity system is arming, and then will flash
slowly until the vehicle is disarmed.
YELLOW WARNING LIGHTS
Anti-Lock Brake System (ABS) Warning
Light
This warning light monitors the ABS. The
light will turn on when the ignition is placed
in the ON/RUN or ACC/ON/RUN position and
may stay on for as long as four seconds.
If the ABS light remains on or turns on while driving,
then the Anti -Lo ck portion of the brake system is not
functioning and service is required as soon as possible.
However, the conventional brake system will continue to
operate normally, assuming the Brake Warning Light is
not also on.
If the ABS light does not turn on when the ignition is
placed in the ON/RUN or ACC/ON/RUN position, have
the brake system inspected by an authorized dealer.
Electronic Stability Control (ESC) Active
Warning Light If Equipped
This warning light will indicate when the
Electronic Stability Control system is Active.
The ESC Indicator Light in the instrument
cluster will come on when the ignition is
placed in the ON/RUN or ACC/ON/RUN position, and
when ESC is activated. It should go out with the engine
running. If the ESC Indicator Light comes o n continu-
ously with the engine running, a malfunction has been
detected in the ESC system. If this warning light
remains on after several ignition cycles, and the vehicle
has been dri ven several miles (kilometers) at speeds
greater than 30 mph (48 km/h), see an authorized
dealer as so on as possible to have the problem diag-
nosed and co rre cted.
136 GETTING TO KNOW YOUR INSTRUMENT PANEL
Loading ...
Loading ...
Loading ...