Loading ...
Loading ...
Loading ...
Screen Setup Driver Selectable Items
Upper Left and Right
None
Current MPG
(or L/100km,
km/L)
Average MPG
(or L/100km,
km/L)
Outside Temp Compass Trip A Distance
Range To Empty Time Trip B Distance
Center
None Compass Time
Outside Temp
Average MPG
(or L/100km,
km/L)
Trip A Distance
Range to Empty Audio Speedometer
Current MPG
(or L/100km,
km/L)
Trip B Distance Menu Title
Favorite Menus
Speedometer Stop/Start Vehicle Info
Off Road –
If Equipped
(show/hide)
Messages
Driver Assist –
If Equipped
(show/hide)
Fuel Economy
(show/hide)
Screen Setup
Trip Info
(Show/Hide)
Audio
(show/hide)
Gear Display — If Equipped
•
Full
•
Single
Current Gear — If Equipped
•
On
•
Off
Odometer — If Equipped
•
Show
•
Hide
Defaults (Restores All Settings To Default Settings)
•
Cancel
•
Restore
The menu with (show/hide) means user can press OK
button to choose show or hide this menu on the instru-
ment cluster display.
Phone Call Status — If Equipped
A pop-up message for an incoming call will appear on
any screen within your instrument cluster. The pop-up
message will appear on your screen until it is cleared
out of the call is ignored, answered, or the calling ends.
NOTE:
The Uconnect Sett ings can be programmed to turn t he
pop-up off. This will not affect the audio menu or any
phone status i nformation
page 201.
Any incoming calls, active ca lls, and outgoing calls will
take the place of your audio information.
A caller’s name will only be displayed if:
•
A number is associated with the call. The phone num-
ber will be displayed in place of the caller’s name.
•
The test/font of the name is not supported by the
instrument cluster. The instrument cluster will not
display anything in place of the name.
•
The caller’s name exceeds the maximum number of
characters. The last t wo to three digits that will fit
will be replaced with “...”.
NOTE:
Any audio information will return to the instru ment clus-
ter once the call has ended.
BATTERY SAVER ON/BATTERY
SAVER MODE MESSAGE —
ELECTRICAL LOAD REDUCTION
ACTIONS — IF EQUIPPED
This vehicle is equipped with an Intelligent Battery Sen-
sor (IBS) to perform additional monitoring of the electri-
cal system and stat us of the vehicle battery.
In cases when the IBS detects charging system failure,
or the vehicle battery conditio ns are deteriorating, elec-
trical load reduction actions will take place to extend
the driving t ime and distance of the vehicle. This is
done by reducing power to or turning off non-es senti al
electrical loads.
Load reduction is only a cti ve when the e ngine is run-
ning. It will display a message if there is a risk of battery
depletion to the point where the vehicle may stall due
to lack of electrical supply, or will not restart after the
current drive cycle.
When load redu cti on is activated, the message “Battery
Saver On” or “Battery Saver Mode” will appear in the
instrument cluster display.
These messages ind ica te t he vehicle battery has a low
state of charge and continues to lose electrical charge
at a rate tha t the charging system cannot sustain.
132
GETTING TO KNOW YOUR INSTRUMENT PANEL
Loading ...
Loading ...
Loading ...