Loading ...
Loading ...
Loading ...
To Open The Sunrider® Top
To open the Sunrider® top, proceed as follows:
1. Fold both sun visors forward against the windshield.
2. Release the header latches from the crossbar by
pulling the handle downward. Make sure the hook is
disengaged from its receiver.
3. From the front of the Sunrider® top, lift and push
the top rearward to the Sunrider® position.
4. Secure the top by using the two hook-and-loop fas-
teners provided with the Sunrider® kit, and wrap
one around the si de rails on each side of the
Sunrider® top to hold it in place.
POWER SLIDING TOP —
IF EQUIPPED
CAUTION!
Lowering of the windshield is NOT recommended in
vehicles equipped with a Power Sliding Top. Damage
will occur to the top as well as the header seal.
If your vehicle is equipped with a Power Sliding Top, the
control switch can be found on the front trim panel, to
the right of the driver’s side sun visor.
NOTE:
•
The power top is non-removable. If desired, the rear
quarter windows can be removed and stored in the
provided storage bag
page 109.
•
The power top will not open in temperatures below
-4°F (-20°C). However, if it is opened at a higher
temperature, it can be closed at temperatures
above -40°F (-40°C).
•
The power top will not operate at vehicle speeds
above 60 mph (96 km/h).
NOTE:
A slight pause in audio may be heard when opening
and closing the Power Sli ding Top as a result of t he
Uconnect system switching between power top Closed
and power top Open audio modes.
Release Both Header Latches
Sunrider® Position
Hook-And-Loop Fastener Placement
Power Sliding Top Control Switch
1 — Open Switch
2 — Close Switch
GETTING TO KNOW YOUR VEHICLE 107
2
Loading ...
Loading ...
Loading ...