Loading ...
Loading ...
Loading ...
3. When the seat belt is long enough to fit, insert the
latch plate into the buckle until you hear a “click.”
4.
Position the lap belt so that it is snug and lies low
across your hips, below your abdomen. To re move
slack in the lap belt portion, pull up on the shoulder
belt. To loosen the lap belt if it is too tight, tilt the latch
plate and pull on the lap belt. A snug seat belt reduces
the risk of sliding under the seat belt in a collision.
5. Position the shou lde r belt across the shoulder and
chest with mini mal, if any slack so that it is comfort-
able and not resting on your neck. The retractor will
withdraw any slack in the shoulder belt.
6. To r ele ase the seat belt, push the red button on the
buckle. The seat belt will automatically retract to its
stowed position. If necessary, slide the latch plate
down the webbing to allow the seat belt to retract
fully.
Lap/Shoulder Belt Untwisting Procedure
Use the following procedure to untwist a twisted lap/
shoulder belt.
1. Position the latch plate as close as possible to the
anchor point.
2. At about 6 to 12 inches (15 to 30 cm) above the
latch plate, grab and twist the seat belt webbing
180 degrees to create a fold that begins immedi-
ately above the latch plate.
3. Slide the latch plate upward over the folded web-
bing. The folded webbing must enter the slot at the
top of the latch plate.
4. Continue to slide the latch plate up until it clears the
folded webbing and the se at belt is no longer
twisted.
Adjustable Upper Shoulder Belt
Anchorage
In the driver and outboard front passenger seats, the
top of the shoulder belt can be adju sted upward or
downward to position the seat belt away from your
neck. Push or squeeze the anchorage button to release
the anchorage, a nd move it up or down to the position
that serves you best.
As a guide, if you are shorter than average, you will pre-
fer t he shoulder belt anchorage in a lower position, and
if you are taller than average, you will prefer the shoul-
der belt ancho rage in a higher position. After you
release the anchorage button, try to move it up or down
to make sure that it is locked in position.
NOTE:
The adjustable u pper shoulder belt anchorage is
equipped with an Easy Up feature. This feature allows
the shoulder belt anchorage to be adjusted in the
upward position without pushing or squeezing the
release button. To verify the shoulder belt anchorage is
latched, pull downward on the shoulder belt anchorage
until it i s locked into position.
WARNING!
•
Wearing your seat belt incorre ctly could make your
injuries in a collision much worse. You might suffer
internal injuries, or you could even slide out of the
seat belt. Follow these instructions to wear your seat
belt safely and to keep your passengers safe, too.
(Continued)
Inserting Latch Plate Into Buckle
Positioning The Lap Belt
Adjustable Upper Anchorage
242 SAFETY
Loading ...
Loading ...
Loading ...