Loading ...
Loading ...
Loading ...
CENTER HIGH MOUNTED STOP LAMP
(CHMSL)
The stop lamp is mounted on a bracket that extends
upward from the swing gate behind the spare tire. If
service is needed, obtain the LED Assembly from an
authorized dealer.
See the following steps to replace:
1. Remove the spare tire.
2. Remove the screws holding the tire carrier cover.
3. Remove two screws from lamp assembly and dis-
connect electrical connector.
LICENSE PLATE LAMPS
See the following steps to replace:
NOTE:
To install a new bulb, reverse the previously mentioned
procedure. When installing the new bulb, care should
be taken to not allow bare skin to come in contact with
the bulb.
See an author ized dealer to replace LED lamps.
TIRES
TIRE SAFETY INFORMATION
Tire safety information will cover aspects of the follow-
ing information: Tire Markings, Tire Identification Num-
bers, Tire Terminology and Definitions, Tire Pressures,
and Tire Load ing.
NOTE:
If your vehicle is equipped with bead-lock wheels,
please refer to your vehicles bead-lock specific part
number for additional information and instructions on
mopar.com or by contacting an authorized de aler.
Tire Markings
NOTE:
•
P (Passenger) — Metric tire sizing is based on US
design standards. P-Metric tires have the letter “P”
molded into the sidewall pre ced ing the size designa-
tion. Example: P215/65R15 95H.
•
European — Metric tire sizing is based on European
design standards. Tires designed to this standard
have the tire size molded into the sidewall beginning
with the sec ti on width. The letter "P" is absent from
this tire size designation. Example:
215/65R15 96H.
•
LT (Light Truck) — Metric tire sizing is based on US
design standards. The size designation for LT-Metric
tires is the same as for P-Metric tires except for the
letters “LT” that are molded into the sidewall pre-
ceding the si ze designation. Example:
LT235/85R16.
•
Temporary spare tires are designed for temporary
emergency use only. Temporar y high pressure com-
pact spare tir es have the letter “T” or “S” molded
into the sidewall preceding the size designation.
Example: T145/80D18 103M.
•
High flotation tire sizing is based on US design stan-
dards and it begins with the tire diameter molded
into the sidewall. Example: 31x10.5 R15 LT.
Tire Markings
1 — US DOT Safety Standards Code
(TIN)
2 — Size Designation
3 — Service Description
4 — Maximum Load
5 — Maximum Pressure
6 — Treadwear, Tract io n and
Temperature Grades
320
SERVICING AND MAINTENANCE
Loading ...
Loading ...
Loading ...