Loading ...
Loading ...
Loading ...
NOTE:
•
In case the ignition switch does not change with the
push of a button, the key fob may have a low or fully
depleted battery. A low key fob battery condition
may be indicated by a message in the instrument
cluster display, or by the LED light on the key fob. If
the LED key fob light no longer illuminates from key
fob button pushes, then the key fob battery requires
replacement.
•
Improper disposal of key fob batteries may be harm-
ful to the environment. Please see an authorized
dealer for proper battery disposal
page 352.
To Lock/Unlock The Doors And Swing
Gate
Push and relea se the unlock button on the key fob once
to unlock the driver’s door, or twice to unlock all the
doors and swing gate. To lock all the doors, push the
lock button once.
When the doors are unlocked, the turn signals will
flash. When the doors are locked, the turn signals will
flash and the horn will chirp.
NOTE:
All doors can be programmed to unlock on the first
push of the unlock button through the Uconnect Set-
tings
page 201.
Key Left Vehicle Feature
If a valid key fob is no longer detected inside the vehicle
while the vehicle’s ignition system is in the ON/RUN or
START position, the message “Key Fob Has Left The
Vehicle” will be shown in the instrument cluster display
along with an interior chime. A n exterior audible and
visual alert will also be activated to warn the driver.
The vehicle’s horn will rapidly chirp three times along
with a single flash of the vehicle’s exterior lights.
NOTE:
•
The doors have to be open and then closed in order
for the vehicle to detect a key fob. The Key Left
Vehicle feature will activate when the first door is
closed and no key fob is detected in the vehicle. If
the warning has been activated, and the other doors
are closed, no other warnings will be issued.
•
These alerts will not be activated i n situations wher e
either the vehicle’s engine is left running with the
key fob inside, or the key fob’s wireless signals are
blocked.
Using The Panic Feature
To turn the Panic feature on or off, push the Panic but-
ton on the key fob. When the Panic feature is activated,
the turn si gnals will flash, the horn may pulse on and
off (if equipped with horn alarm), and the interior lights
will turn on.
The Panic feature will stay on for three minutes unless
you turn it off by either pushing the Panic button a sec-
ond time o r drive the vehicle at a speed of 15 mph
(24 km/h) or greater.
NOTE:
•
The interior lights will turn o ff if you place the igni-
tion in the ON/RUN position while the Panic feature
is activated. However, the exterior lights and horn
(if equipped with horn alarm) will remain on.
•
You may need to be closer than 66 ft (20 m) from
the vehicle when using the key fob to turn off the
Panic feature due to the radio frequency noises
emitted by the system.
Replacing The Battery In The Key Fob
The recommended replacement battery is CR2450.
NOTE:
•
Customers are recommended to use a battery
obtained from Mopar®. Aftermarket coin battery
dimensions may not meet the original OEM coin
battery dimensions.
•
Perchlorate Material — special handling may apply.
See www.dtsc.ca.gov/hazardouswaste/perchlorate
for further information.
•
Do not touch the battery terminals that are on the
back housing or the printed ci rcuit board.
•
When a key fob battery is low, a warning will be indi-
cated on the vehicle’s instrument cluster, and the
fob LED will no longer illuminate with a button press.
1.
Remove the back c over of the fob by inserting a flat-
blade screwdriver into the slot on the bottom of the
fob. Pry until the cover unsnaps being careful not to
damage the seal. Proceed counterclockwise to pr y the
remaining snaps unti l the battery cover can be
removed.
1-3 – Back Cover Pry Points
32
GETTING TO KNOW YOUR VEHICLE
Loading ...
Loading ...
Loading ...