Loading ...
Loading ...
Loading ...
WARNING!
•
The jack is designed to be used as a tool for
changing tires o nly. The jack should not be used to
lift the vehicle for service purposes. The vehicle
should be jacked on a fir m level surface only. Avoid
ice or sli ppery areas.
PREPARATIONS FOR JACKING
1. Park on a firm, level surface. Avoid ice or slippery
areas.
WARNING!
Do not attempt to change a tire on the side of the
vehicle close to moving traffic. Pull far enough off the
road to avoid being hit when operating the jack or
changing the wheel.
2. Turn on the Hazard Warning Flashers.
3. Apply the parking brake.
4. Shift the automatic transmission into PARK (P), or a
manual transmission into REVERSE (R).
5. Turn the ignition OFF.
6. Block both the front and rear of the wheel diagonally
opposite of the jacking position. For example, if the
driver’s front wheel is being changed, block the pas-
senger’s rear wheel.
NOTE:
Passengers should not remain in the vehicle when the
vehicle is being lifted or raised.
JACK LOCATION
The jack and lug wrench are located in the rear cargo
area. To remove jack and tools proceed as follows:
1. Lift the load floor in the cargo area.
NOTE:
The load floor can be removed for easier access by
pulling the load floor handle up and directly rearward.
2. Remove the hardware storage cover by pinching the
latch on the left side and pulling upward.
3. Turn the plastic wing nut counterclockwise to loosen
the jack from the storage bin.
4. Remove tool kit and assemble tools.
Wheel Blocked Example
Load Floor Handle
Hardware Storage Cover Latch
Plastic Wing Nut Location
IN CASE OF EMERGENCY 27 1
7
Loading ...
Loading ...
Loading ...