Loading ...
Loading ...
Loading ...
Engine Air Cleaner Filter Inspection and
Replacement — 6.4L Engine
Follow the recommended maintenance intervals as
shown in the Maintenance Plan in this section.
Engine Air Cleaner Filter Removal
1. Loosen the fasteners from the air cleaner cover
using a suita ble tool.
2. Lift the engine air cleaner filter cover to access the
engine air cle aner filter by rotating at the hinge and
pulling the cover away from the engine.
3. Remove the engine air cleaner filter from the hous-
ing assembly.
Engine Air Cleaner Filter Installation
NOTE:
Inspect and clean the housing if significant dirt or
debris is pr ese nt before replacing the engine air
cleaner filter.
1. Install the engine air cleaner filter into the housing
assembly with the engine air cleaner filter inspec-
tion surface facing downward.
2. Tighten engine air cleaner filter cover fasteners
using a suita ble tool.
CAUTION!
Do not overtighten the engine air cleaner filter cover
lid screws or damage may result.
ACCESSORY DRIVE BELT
INSPECTION
WARNING!
•
Do not attempt to inspect an accessory drive belt
with the vehicle running.
•
When working near the radiator cooling fan, dis-
connect the fan motor lead. The fan is temperature
controlled and can st art at any time regardless of
ignition mode. You could be injured by the moving
fan blades.
•
You can be badly injured working on or around a
motor vehicle. Only do service work for which you
have the knowledge a nd the proper equipment. If you
have any doubt about your ability to perform a ser-
vice job, take your vehicle to a competent mechanic.
When inspecting accesso ry drive belts, small cracks that
run across the ribbed surface of the belt, from rib to rib,
are considered normal. These are not a reason to replace
a belt. However, cracks running along a rib (not across)
are not normal. Any belt with cracks running along a ri b
must be replaced . Also have the belt replaced if it has
excessive wear, frayed cords, or severe glazing.
Conditions that would require replacement:
•
Rib chunking (one or more ribs has separated from
belt body)
•
Rib or belt wear
•
Longitudinal belt cracking (cracks between two ribs)
•
Belt slips
•
Groove jumping (belt does not maintain correct posi-
tion on pulley)
•
Belt broken
•
Noise (objectionable squeal, squeak, or r umble is
heard or felt while drive belt is in operation)
NOTE:
Identify and c orr ect problem before new belt is
installed.
Some conditions can be cause d by a faulty component
such as a belt pulley. Belt pulleys should be carefully
inspected for damage and proper alignment.
Belt replacement on some mod els requires the use of
special tools, we recommend having your vehicle ser-
viced at an authorized de aler.
Engine Air Cleaner Cover
1 — Engine Air Cleaner Filter Cover
2 — Fasteners
Accessory Belt (Serpentine Belt)
296 SERVICING AND MAINTENANCE
Loading ...
Loading ...
Loading ...