Loading ...
Loading ...
Loading ...
4. Making sure the lift assist mechanism is in the
“lock” position, lift the soft top into the rear o f the
vehicle with the side links pointing toward the front.
Lower the lift assist mechanisms onto its retainers
on both sides (on the inside of the sport bar).
5. Using the provided #40 Torx head driver and
ratchet, tighten the Torx screws by turning them
clockwise. Secure them until t hey are snug (refer to
the following table for recommended torque specifi-
cations), being car efu l not to cross-thread the
screws or overtighten. Repeat on the opposite side.
Torque
Specification
For Torx Screws
Maximum Minimum
119.5 in-lb 150.5 in-lb 106.2 in-lb
13.5 N·m 17.0 N·m 12.0 N·m
CAUTION!
Do not overtighten the screws. You can strip the
screws if they are overtightened.
6. While pulling the release lever on the top of the rail
rearward, place the side link into the guide track on
the top of the rail then release the lever.
7. Unsnap and remove the black boot cover. This cover
should be di scarded. It was intended as a protective
cover for shipping only.
8. Raise the soft top
page 93.
NOTE:
Be sure t he wire harness in the left rear corner is
not tangled in the soft top bows before you lift the
top.
Step Four
Step Four
Step Five
1 — Lock Position
2 — Torx Head Screw
3 — Torx Head Screw
Step Six
98 GETTING TO KNOW YOUR VEHICLE
Loading ...
Loading ...
Loading ...