Loading ...
Loading ...
Loading ...
NOTE:
•
The charging system is independent from loa d
reduction. The charging system performs a diagnos-
tic on the charging system continu ou sly.
•
If the Battery Charge Warning Light is on it may indi-
cate a problem with the charging system
page 134.
The following are electrical loads that may be switched
off (if equipped), and vehicle functions whi ch can be
affected by load reduction:
•
Heated Seat/Vented Seats/Heated Wheel
•
Rear Defroster And Heated Mirrors
•
HVAC System
•
150W Power Inverter System
•
Audio and Telematics System
Loss of the battery charge may indicate one or more of
the following conditions:
•
The charging system cannot deliver enough electri-
cal power to the vehicle system because the electri-
cal loads are larger than the capability of the charg-
ing system. The charging system is still functioning
properly.
•
Turning on all possible vehicle electrical loads (e.g.
HVAC to max settings, exterior and interior lights,
overloaded power outlets +12 Volt, 150W, USB
ports) during certain driving conditions (city driving,
towing, frequent stopping).
•
Installing options li ke additional lights, upfitter elec-
trical accessories, audio systems, alarms and simi-
lar devices.
•
Unusual driving cycles (short trips separated by long
parking periods).
•
The vehicle was parked for an extended period of
time (weeks, months).
•
The battery was recently re placed and was not
charged completely.
•
The battery was discharged by an electrical load left
on when the vehicle was parked.
•
The battery was used for an extended period with
the engine not running to supply radio, lights, char-
gers, +12 Volt portable appliances like vacuum
cleaners, game co nsoles and similar devices.
What to do when an electrical load reduction action
message is present (“Battery Saver On” or “Battery
Saver Mode”)
During a tri p:
•
Reduce power to unnecessary loads if possible:
○ Turn off redundant lights (interior or exterior)
○ Check what may be plugged in to power outlets
+12 Volt, 150W, USB ports
○ Check HVAC settings (blower, temperature)
○ Check the audio settings (volume)
After a trip:
•
Check if any aftermarket equipment was installed
(additional lights, upfitter electrical accessories,
audio systems, alarms) and review specifications if
any (load and Ignition Off Draw currents).
•
Evaluate the latest driving cycles (distance, driving
time and par king time).
•
The vehicle should have service performed if the
message is sti ll present during consecutive trips
and the evaluation of the vehicle and driving pattern
did not help to identify the cause.
WARNING LIGHTS AND MESSAGES
The warning/indicator lights will illuminate in the instru-
ment panel together with a dedicated message and/or
acoustic signal when applicable. These indications ar e
indicative and precautionary and as such must not be
considered as exhaustive and/or alternative to the
information contained in the Owner’s Manual, which
you are advised to read carefully in all cases. Always
refer to the information in this chapter in the event of a
failure indication. All active telltales will display first if
applicable. The system che ck menu may appear dif fer-
ent based upo n equipment options and current vehicle
status. Some telltales are optional and may not appear.
RED WARNING LIGHTS
Air Bag Warning Light
This warning light will illuminate to indicate a
fault with the air bag, and will turn on for
four to eight seconds as a bulb check when
the ignition is placed in the ON/RUN or ACC/
ON/RUN position. This light will illuminate with a single
chime when a fault with the air bag has been detected,
it will stay on until the fault is cleared. If the light is not
on during sta rtup, stays on, or turns on while driving,
have the system inspected at an authorized dealer as
soon as possible .
GETTING TO KNOW YOUR INSTRUMENT PANEL 133
3
Loading ...
Loading ...
Loading ...