Loading ...
Loading ...
Loading ...
•
Press the heated seat button a third time to turn the
LO setting on.
•
Press the heated seat button a fourth time to turn
the heating e leme nts off.
NOTE:
•
The engine must be running for the heated seats to
operate.
•
The level of heat selected will stay on until the
operator changes it.
For information on use with the Remote Start system,
see
page 38.
WARNING!
•
Persons who are unable to feel pain to the skin
because of a dvanced age, chronic illness, diabe-
tes, spinal cord injury, medication, alcohol use,
exhaustion or other physical condition must exer-
cise care whe n using the seat heater. It may cause
burns even at low temperatures, especially if used
for long periods of time.
•
Do not place anything on the seat or seatback that
insulates against heat, such as a blanket or cush-
ion. This may cause the seat heater to overheat.
Sitting in a seat that has been overheated could
cause serious burns due to the increased sur face
temperature of the seat.
HEAD RESTRAINTS
Head restraints are designed to reduce the risk of injury
by restricting head movement in the event of a rear
impact. Head restraints should be adjusted so that the
top of the head restraint is located above the top of
your ear.
WARNING!
•
All occupants, inc lud ing the driver, should not oper-
ate a vehicle or sit in a vehicle’s seat until the
head restraints are placed in their proper pos iti ons
in order to minimize the risk of neck injury in the
event of a crash.
•
Head restraints should never be adjusted while the
vehicle is in motion. Driving a vehicle with the head
restraints improperly adjusted or removed could
cause serious injury or death in the event of a
collision.
Front Head Restraints
To raise the head restraint, pull upward on the head
restraint. To lower the head restraint , push the adjust-
ment button located on the base of the head restraint,
and push downward on the head restraint. The release
button does not need to be pushed to adjust the head
restraint.
To remove the head restraint, raise it as far as it can go
then push the adjustment button and the release but-
ton at the base of e ach post while pulling the head
restraint up. To reinstall the head restraint, put the
head restraint posts into the holes and push downward.
Then adjust it to the appropriate height.
WARNING!
•
A loose head restraint thrown forward in a collision
or hard stop could cause serious injury or death to
occupants of t he vehicle. Always securely stow
removed head restraints in a location outside the
occupant compartment.
•
ALL the head restraints MUST be reinstalled in the
vehicle to properly protect the occupants. Follow
the reinstallation instructions prior to operating the
vehicle or occupying a seat.
NOTE:
Do not reposition the head restraint 180 degrees to the
incorrect position in an attempt to gain additional clear-
ance to the back of t he head.
Front Head Restraint
1 — Release Bu tton
2 — Adjustment Button
GETTING TO KNOW YOUR VEHICLE 63
2
Loading ...
Loading ...
Loading ...