Loading ...
Loading ...
Loading ...
40
Task 3: Set the Linkage Method for Motion Detection.
Click Linkage Method and check the checkbox to select the linkage method. Notify surveillance
center, send email, upload to FTP/Memory Card/NAS, trigger recording and trigger alarm output
are selectable. You can specify the linkage method when an event occurs.
Note: Linkage method may vary according to different models.
Notify Surveillance Center: Send an exception or alarm signal to remote management software
when an event occurs.
Send Email: Send an email with alarm information to a user or users when an event occurs.
Upload to FTP/Memory Card/NAS: Capture the image when an alarm is triggered and upload
the picture to a FTP server, local memory card, or network attached storage (NAS).
Notes:
1. Go to Configuration > Storage > Schedule Settings > Capture > Capture Parameters page,
enable the event-triggered snapshot, and set the capture interval and capture number.
2. The captured image can also be uploaded to the memory card or network disk if available.
Trigger Recording:The video will be recorded when the motion is detected. You have to set the
recording schedule first.
Trigger Alarm Output: Trigger one or more external alarm outputs when an event occurs.
Note: Go to Configuration > Event > Basic Event > Alarm Output > Alarm Schedule page, set the
arming schedule of the alarm output.
Expert Configuration
Expert mode is mainly used to configure the sensitivity and proportion of object on each area for
different Scheduled Image Settings at day and night.
Scheduled Image Settings: OFF
Loading ...
Loading ...
Loading ...