Loading ...
Loading ...
Loading ...
22
If you have no router but only a modem, you can use Point-to-Point Protocol over Ethernet
(PPPoE) function.
1. Click PPPoE tab to enter the PPPoE configuration interface.
2. Check the Enable PPPoE checkbox to enable this feature.
3. Enter User Name, Password, and Confirm password for PPPoE access. The user name and
password is assigned by your ISP.
4. Click Save to save the settings.
Multicast
You can set up active multicast on this page.
IP Address: It stands for the multicast address. The range of the multicast IP address is
224.0.0.19 to 239.255.255.255.
Video port and audio port of each video stream of each camera channel can be specified by
selecting a stream in Video Stream and inputting port number in Video Port and Audio Port.
FEC Port and FEC Ratio: Set the port and ratio of Forward Error Correction.
SRTP: The default video port is 18860 and the default audio port is 18862.
Note: Only certain camera models support FEC port, FEC ratio, and SRTP.
5.3.2 Advanced Settings
SNMP
SNMP settings is used to get the camera status, parameters and alarm related information and
manage the camera remotely when it is connected to the network.
Before setting the SNMP, please download the SNMP software and manage to receive the
camera information via SNMP port. By setting the Trap Address, the camera can send the alarm
event and exception messages to the surveillance center.
1. Click SNMP tab to enter the SNMP configuration interface.
2. Check the corresponding version checkbox to enable the feature.
3. Configure the SNMP settings.The settings of the SNMP software should be the same as the
settings you configure here.
4. Click Save to save the settings.
Note: To avoid the risk of information leakage, you are suggested to enable SNMP v3 instead of
SNMP v1 or v2.
802.1X
802.1X standard is used to secure the data. And user authentication is needed when camera is
connected to the network protected by the IEEE 802.1X.
Before you start, the authentication server must be configured. Please apply and register a user
name and password for 802.1X in the server.
1. Click 802.1X tab to enter the 802.1X configuration interface.
2. Check the Enable IEEE 802.1X checkbox to enable the feature.
3. Select the protocol. EAP-LEAP, EAP-TLS and EAP-MD5 are available.
Loading ...
Loading ...
Loading ...