Loading ...
Loading ...
Loading ...
19
5.3 Network
5.3.1 Basic Settings
TCP/IP
TCP/IP settings must be properly configured before you operate the camera over network. The
camera supports both the IPv4 and IPv6. Both versions may be configured simultaneously
without conflicting with each other, and at least one IP version should be configured.
1. Click TCP/IP tab to enter the TCP/IP configuration interface.
2. For the cameras support Wi-Fi, there are two NIC tabs selectable. One for LAN and the other
one for WLAN. Click the tab to configure the parameters of the selected NIC.
3. Configure the basic network settings, including the NIC Type, IPv4 or IPv6 Address, IPv4 or
IPv6 Subnet Mask, IPv4 or IPv6 Default Gateway, MTU [1280~1500] settings and Multicast
Address.
NIC Type: Select a NIC (Network Interface Card) type according to your network condition
IPv4:Two IPv4 modes are available.
DHCP: The device automatically gets the IPv4 parameters from the network if you check
DHCP. The device IP address is changed after enabling the function. You can use SADP to get
the device IP address.
Manual:You can set the device IPv4 parameters manually. Input IPv4 Address, IPv4 Sub net
Mask, and IPv4 Default Gateway, and click Test to see if the IP address is available.
IPv6: Three IPv6 modes are available.
MTU:It stands for maximum transmission unit. It is the size of the largest protocol data unit
that can be communicated in a single network layer transaction. The valid value range of
MTU is 1280 to 1500.
4. (Optional) Check the checkbox of Enable Multicast Discovery, and then the online network
camera can be automatically detected by client software via private multicast protocol in the
LAN.
Multicast Discovery:Check the Enable Multicast Discovery, and then the online network
camera can be automatically detected by client software via private multicast protocol in the
LAN.
5. (Optional) If DNS is required, input the address of Preferred DNS Server and Alternate DNS
Server.
DNS:It stands for domain name server. It is required if you need to visit the device with
domain name. And it is also required for some applications (e.g., sending email). Set
Preferred DNS Server and Alternate DNS server properly if needed.
6. (Optional) If Dynamic Domain Name is required, check the checkbox to enable the function,
and input the preferred domain name.
Dynamic Domain Name: Check Enable Dynamic Domain Name and input Register Domain
Name. The device is registered under the register domain name for easier management
within the local area network.
7. Click Save to save the settings.
Loading ...
Loading ...
Loading ...