Loading ...
Loading ...
Loading ...
13
DST
Check the Enable DST checkbox to enable DST (Daylight Saving Time).
Select the start time,end time, and DST Bias, and click Save to activate the settings.
RS485
Note: The function is only supported by certain camera models.
The RS-485 serial port is used to control the PTZ of the camera. The configuring of the PTZ
parameters should be done before you control the PTZ unit.
By default, the default baud rate is set as 9600 bps, the Data Bit is 8, the stop bit is 1 and the
Parity and Flow Control is None.
RS232
The RS-232 port can be used in two ways:
Console: Connect a computer to the camera through the serial port. Device parameters can be
configured by using software such as Hyper Terminal. The serial port parameters must be the
same as the serial port parameters of the camera.
Transparent Channel: Connect a serial device directly to the camera. The serial device will be
controlled remotely by the computer through the network.
Loading ...
Loading ...
Loading ...