Loading ...
Loading ...
Loading ...
Synchronizing the universal remote control with
the system:
1. Park the vehicle within range of the remote-
controlled system.
2. Program the relevant button on the interior
mirror as described.
3. Locate and press the synchronizing button
on the system being programmed, e.g. at the
garage gate. You have approx. 30 seconds
for the next step.
4. Hold down the programmed button on the in‐
terior mirror for approximately 3 seconds and
then release it. If necessary, repeat this step
up to three times in order to finish synchroni‐
zation. Once synchronization is complete, the
programmed function will be carried out.
Reprogramming individual
buttons
1.
Switch on standby state.
2. Press and hold the interior mirror button to be
programmed.
3. As soon as the LED on the interior mirror
flashes orange after approx. 20 seconds, re‐
lease the button.
4. Hold the hand-held transmitter for the system
to be used approx. 1 to 12 in/2.5 to 30 cm
away from the buttons on the interior mirror.
The required distance depends on the hand-
held transmitter.
5. Press and hold the button of the desired
function on the hand-held transmitter.
Canada: if programming with the hand-held
transmitter was interrupted, hold down the in‐
terior mirror button and repeatedly press and
release the hand-held transmitter button for
2 seconds.
6. The LED can light up in different ways.
▷ The LED lights up green: the program‐
ming procedure is completed.
Release the button.
▷ The LED flashes fast: the hand-held
transmitter was detected but program‐
ming is not complete.
Press the button on the interior mirror for
2 seconds and release. Perform this pro‐
cedure three times to complete the pro‐
gramming procedure.
If the integrated universal remote control
remains nonoperational, continue with the
special features for change code wireless
systems.
▷ LED does not flash green after 60 sec‐
onds: programming not completed.
Repeat steps 3 to 6.
If the programming procedure is not completed,
the previous programming will remain un‐
changed.
Operation
Warning
The operation of remote-controlled systems
with the integrated universal remote control,
such as the garage door, may result in injury,
for example, body parts becoming jammed in a
garage door. There is a risk of injury or risk of
damage to property. Make sure that the area of
movement of the respective system is clear
during programming and operation. Also follow
the safety information of the hand-held trans‐
mitter.
The system, such as the garage door, can be op‐
erated using the button on the interior mirror
while the drive-ready or standby state is
switched on. To do this, hold down the button
within receiving range of the system until the
function is activated. The interior mirror LED
stays lit while the wireless signal is being trans‐
mitted.
Deleting stored functions
All stored functions will be deleted. The func‐
tions cannot be deleted individually.
Seite 290
CONTROLS
Interior equipment
290
Online Edition for Part no. 01402667211 - VI/19
Loading ...
Loading ...
Loading ...