Loading ...
Loading ...
Loading ...
The braking intervention occurs only if vehicle
stability has not been restricted, for instance by
deactivating the DSC Dynamic Stability Control.
The driver may interrupt the braking intervention
function by stepping on the accelerator pedal or
by actively moving the steering wheel.
The system’s ability to detect objects may be
limited in some circumstances. Refer to the in‐
formation in this Owner’s Manual regarding the
limitations of the system and actively intervene
as warranted.
System limits
Safety information
Warning
The system is designed to operate in certain
conditions and circumstances. Due to condi‐
tions or other factors, the system may not re‐
spond. There may be a risk of accident or risk
of damage to property. Actively intervene as
warranted. Refer to the information in this Own‐
er’s Manual regarding the scope of the sys‐
tem’s operation and limitations.
Detection range
The system's detection potential is limited.
Only objects that are detected by the system are
taken into account.
Thus, a system reaction might not come or
might come late.
The following situations may not be detected, for
instance:
▷ Slow moving vehicles when you approach
them at high speed.
▷ Vehicles that suddenly swerve in front of you,
or sharply decelerating vehicles.
▷ Vehicles with an unusual rear appearance.
▷ Two-wheeled vehicles ahead of you.
Upper speed limit
If the vehicle speed exceeds approx.
155 mph/250 km/h, the system is deactivated
temporarily. When the vehicle slows down to be‐
low this speed, the system is reactivated.
Functional limitations
The system may not be fully functional in the fol‐
lowing situations:
▷ In heavy fog, wet conditions, or snowfall.
▷ In tight curves.
▷ If the driving stability control systems are lim‐
ited or deactivated, for instance DSC OFF.
▷ If the field of view of the camera or the wind‐
shield is dirty or covered in the area of the in‐
terior mirror.
▷ If the camera has overheated and been tem‐
porarily switched off due to excessively high
temperatures.
▷ Depending on the equipment: if the radar
sensors are dirty or covered.
▷ After improperly performed work on the vehi‐
cle paint in the area of the radar sensors.
▷ Up to 10 seconds after the start of the engine
via the Start/Stop button.
▷ During calibration of the camera immediately
after vehicle delivery.
▷ If there are constant blinding effects because
of oncoming light, for instance from the sun
low in the sky.
Attaching any objects such as stickers or film in
the beam area of the radar sensors will also im‐
Seite 180
CONTROLS
Safety
180
Online Edition for Part no. 01402667211 - VI/19
Loading ...
Loading ...
Loading ...